Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
When your trailer is over 80" wide, visibility and compliance matter. This Optronics identification light bar measures 14-1/4" long x 1-3/16" tall x 1-5/16" deep and features three red 3-LED lights—nine diodes total—mounted on a corrosion-resistant stainless steel base. The lights are DOT compliant and P2 or P3 rated for clear, bright output across a 90-degree beam spread. With only a 0.153-amp draw at 12.8V, it offers strong illumination without overloading your running light circuit.
If your trailer ever backs into the water, this light bar is ready for it. Each red LED module is sonically sealed with its polycarbonate lens to form a single waterproof unit. The sealed design keeps moisture out so the diodes and circuit board stay protected from corrosion or shorts—even after repeated submersion. It’s a dependable choice for any trailer that sees rain, spray, or launch ramps.
Long days on the road or at the dock can be hard on lighting hardware. The stainless steel base of this bar resists rust and corrosion far better than coated steel or plastic mounts. It stays secure and good-looking season after season while keeping the three light modules solidly supported for steady performance.
Wiring doesn’t need to be complicated. This light bar uses a single power wire with a molded 0.180" male bullet connector that ties into your running light circuit. The ground connection is made through the mounting hardware, making installation straightforward. You’ll just need two 5/8" x 1/4" stainless steel screws (not included) to mount it securely with an 8-1/2" center-to-center hole spacing.
Forget about burned-out bulbs or fragile filaments. These LEDs last up to 50 times longer than incandescent lights and deliver brighter output with less power draw. There are no bulbs to replace—just steady, maintenance-free lighting backed by a lifetime LED warranty so you can focus on towing instead of troubleshooting lights.

Customer Satisfaction Score:
99% were satisfied with this product
1% of customers were not satisfied
Ratings & Reviews

Td
9/16/2018
Lights are all still working great, zero problems. Trailer is stored outside and the boat is used in fresh water.

Jim S.
10/17/2017
All trailer parts are doing well. Saltwater even.

James P.
3/12/2017
All products purchased from E-trailer have and are being used. The lights in particular are good quality, fit and finish and have exceeded my expectations.

Albert A.
5/10/2021
Great!
Do you have a question about this Trailer Light?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.











Allena
10/25/2016
The Optronics Trailer Lights are working perfectly. They add that difference when Im towing my 9 foot wide boat.Thanks for the follow up,