Replacement Bearings And Seals For Dexter Axle Part # 649936

Question

Question:

I would like to get a bearing set and seal to bring with for our new 5th wheel camper. its a dexter axle #649936 s/n 131293292 , 6000 lb thanks

asked by: Bruce D

0

Expert Reply:

Per Dexter, the correct bearings and seals for your axle would be # 25580, # 14125A, and 10-36 # RG06-070. These can all be purchased together in a kit with part # BK3-200 if you need a new cotter pin and the races as well.

expert reply by: Kevin C

0

Answer 1

Most axles rated at 3,500 lbs will have the inner bearing, part #L68149, and the outer bearing, part #L44649. This is something you can check. The bearings and seals have numbers. They are actually engraved on the bearings and the seals. If you are…

view full answer...

Answer 2

Your Dexter 6,000lbs axle more than likely uses the grease seal #RG06-070 which has a 2.250" I.D. and the standard 3.376" O.D, though some use the smaller seal #GS-2125DL that has a 2.125" I.D. instead. The only way to confirm this is…

view full answer...

Answer 3

You can use the Timken Grease and Oil Seal #TMK98ZR in place of the Grease Seal #GS-2250DL. While they are not exactly the same seal construction it is still a double lip design and the dimensions are the same so they are going to fit correctly.

view full answer...

Answer 4

To swap over to oil bath you can just swap out the bearings, grease seal, and caps but I'll need a bit more info in order to determine the correct fit for your setup. If you don't need to trailer for a bit you can remove one of the hubs and…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Replacement Bearings And Seals For Dexter Axle Part # 649936

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching