Replacing Bearings On A 1985 Holsclaw 1,000lb Boat Trailer
Updated 09/07/2023 | Published 09/06/2023
Products Featured in This Question
Question:
Im looking for a wheel bearing kit for my 1985 Holsclaw, 1000-lb, boat trailer. Do you have any suggestions?
asked by: Eric
Expert Reply:
I can certainly point you in the right direction. Unfortunately I am not able to recommend bearings based on just a year, make and model of trailer. If only it were so easy right? We would need to have you measure and verify some info. Specifically we would need to know bearing numbers/sizes. If you can remove and unpack a hub we should be able to identify the sizes. Especially since the trailer is almost 40 years old, as they did not use the same standard bearing sizing back then as they do now.
A lot of smaller trailers today will use bearings like the # L44649 (1.063" inner diameter) or a # L44643 (1" inner diameter. Since your trailer is only 1,000 lbs I am assuming that it has a light duty axle that would use one of these smaller bearing sizes or something similar. Only one way to know for sure and that is to unpack a hub and see for yourself.
I have included a picture that shows the measurements needed for a spindle, bearings, seals, faces, and hubs.
(click to enlarge)
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - L44643
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.00 Inch I.D.
- Bearing L44643
- Race L44610
- 2000 lbs Axle
- etrailer
more information >
Continue Researching
- Search Results: trailer bearings races seals caps
- Search Results: loading ramps
- Shop: Trailer Wiring
- Video: Review of TecNiq Trailer Lights - Tail Lights - TN92TR
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Shop: Vehicle Tow Bar Wiring
- Video: Detailed Breakdown of the Optronics ThinLine LED Trailer Tail LIght
- Video: Feature Breakdown: Hopkins Tail Light Converter
- Video: Curt 2 to 3 Wire Tail Light Converter: The Breakdown
- Q&A: How to Wire a Third Brake Light on Trailer
- Q&A: Brake Light Logic Module for Use With 3rd LED Brake Light
- Shop: TecNiq Low Profile Third Brake Light - 15.5" - Red Lens
- Q&A: How to Separate the Turn Signal from Stop Lights on Trailer Wiring
- Shop: 3rd Brake Light Logic Module
- Shop: 2-to-3 Tail Light Converter for Towed Vehicles w/ Incandescent Tail Lights
- Shop: Optronics ThinLine LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 11 Diodes - Clear Lens
- Shop: Curt 2-to-3 Tail Light Converter for Towed Vehicles w/ Incandescent Tail Lights
- Shop: Double Lip Grease Seal - ID 1.249" / OD 1.983" - Qty 1
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Replacement Bearings and Seals for Agricultural Hub
- Q&A: Grease Seal Recommendation for an Old Boat Trailer