Optronics Trailer Lights - TLL160RK

8-1/16" x 2-7/8" Rectangle. Waterproof lights act as brake, tail, turn, side marker, side reflex, rear clearance, rear reflex, and license plate light for trailers wider than 80". Surface mount - hardware included. 3-Wire pigtail.

Features:

• Rectangular combination tail lights are designed to serve 7 functions on trailers over 80" wide when properly mounted
  • Stop, tail, turn, side marker, side reflex, rear clearance, and rear reflex
  • Built-in license plate light on driver's-side light illuminates license plate
• Sealed, waterproof construction is submersible
  • Designed for marine trailer applications
• Durable surface-mount technology (SMT) construction of LED circuit board
  • Better withstands shock and vibration
  • Allows for improved heat distribution
• LEDs make great replacements for incandescent lights
  • Last 50 times longer
  • More efficient - provide brighter light with less power output
  • No bulbs to replace - no brittle filaments
• Red acrylic lens screws on and can be easily replaced
• Molded plastic housing
• Mounts on surface of trailer - hardware included
• 3-Wire pigtail
• DOT compliant
  • Meets FMVSS 108 and CMVSS 108 requirements for automotive lighting
• P2 rated

Specs:

• Configuration: driver side (STL17RB)
  • Passenger side (STL16RB)
• Dimensions: 8-1/16" long x 2-7/8" tall x 2-13/16" deep
• Total diodes: 40
  • Driver's-side light: 22 diodes
  • Passenger's-side light: 18 diodes
• Power draw at 12.8 volts:
  • Stop/turn signal light: 0.259 amps
  • Tail light: 0.062 amps
• Lifetime warranty on LEDs

Sealed, Waterproof Trailer Light

The waterproof construction of these lights make them ideal for use on trailers that may be submerged, like a boat trailer. Each circuit board is sealed, which means that water will not damage the diodes or circuit board.

Combination Lights for Trailers Over 80" Wide

If a trailer is 80" or wider at its widest point, then it requires rear clearance lights in addition to basic trailer lights. These clearance lights indicate the width of the trailer when it is viewed from the back.

To meet these requirements on a flatbed utility trailer where the bed extends past the wheels, you can install combination trailer lights that include the rear clearance function. For proper mounting, the lights must be installed at the widest points on the rear of the trailer - one on each corner.

P2-Rated or P3-Rated Lights

A P2-rated or P3-rated light produces a 45-degree angle of light to either side of its centerline for a total of 90 degrees of coverage. This beam pattern can be seen straight on, but it cannot be seen clearly from the side. So this type of light can be used as either a side marker light or a clearance light, but it cannot function as both. If you need both functions, then you must install 2 separate lights on your trailer - one as a front or rear clearance light and one as a side marker light.

TLL160RK Optronics Combination LED Trailer Taillights for Boat and Marine Trailers More Than 80" Wide - Left Side and Right Side - Red Lens

STL16RB and STL17RB