ThinLine Mini LED Side Marker or Clearance Light w/ Bracket Review Video

I sure can! Based on the picture you provided the correct replacement fender for your trailer is going to be the Plastic, Single-Axle Trailer Fender w/ Top and Side Steps - White - 13" to 15" #PF11X35W which will work perfectly with the…

The simplest option would be to install the Correct Track Trailer Alignment and Lift Kit #LC87120 on your trailer. This will allow you to raise the trailer frame from the axle 1-1/4" or 2-1/4". It will also allow you to shift the axle so it…

I was able to go out to the warehouse and measure the mounting brackets holes for the PF11X35W and found that it was 5-5/16 inches or 5.3125 inches. If these aren't an exact match, new holes can usually be drilled into the brackets to make them…

I can give you a list of parts below that will be needed to rewire a trailer which you can then use when combined with the labor rate of the shop to give you an estimate but it can be very hard to estimate the price of said job because the labor…

It sounds like you have a wishbone wiring harness install on your trailer. A regular 4-way wiring harness has 4 wires from the back of the connector, 1 for left turn/brake typically (yellow), 1 for the right turn/brake typically (green), 1 for the…

I do have options for you but most of our frame mounted spare tire carriers are not designed to work with angle iron. That said, the CE Smith Spare Tire Carrier for Trailers part #CE22007Z-11050-2 we have found to work the best so that's what I…

Either one is fine to do. With the Fulton Hi-Mount Spare Tire Carrier part #FSTC1000301 you are not going to be adding a great deal of width to your trailer so the difference is minimum. Giving you my opinion since there is no rule I would Choose the…

It seems to me that your best bet would be to enlarge the hole slightly, and then push the wires back in once the connections are made. I would use a utility knife with a new blade to carefully enlarge the hole, being careful not to nick the wires.…

The recommended minimum clearance between gooseneck trailer overhang and truck bed rails is 4-6 inches. I'd recommend 6 inches but a lot of people get by with just 4. Ideally you have at least 6 inches of clearance and the trailer is sitting…

Shoreland'r parts are not something that we carry but their numbers are often associated with common parts. The 4410275 is the same as the GS-1250XDL which doesn't come back to anything we have information on. There is a GS-1250DL which…

I looked up some photos of a 2004 Roadtrek 190 online and the rear upper clearance lights appear to be very similar to the ThinLine Mini LED Side Marker or Clearance Light part #MCL-91RK so that is what I recommend using for replacement. If these…

If you installed your Titan Solenoid Valve #T4748800 downstream of your master cylinder for reasons of space it will still operate properly according to my contact at Titan. It does however need to be oriented in one specific direction. The brake…