Search: boat trailer lights   >  

Thanks for the picture. I went ahead and checked out what we have that matches that style of plug, and unfortunately we do not have anything that matches what you are needing. The closest 3-prong wire we have is the 3-Wire Pigtail for Trailer Tail…

Hey Russ, sorry for any confusion but the trailer taillight kits we offer like the Optronics part #TLL9RK that you referenced all use standard 4-way connectors. So they would plug right up to the 4-way of your vehicle.

Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.

The best solution for your situation would be to use a circuit tester, like part #PTW2993, to wire your trailer wires to a seven-way trailer connector, like part #A7WCB. Wiring by function is the best way to make sure you have the trailer connector…

There are a number of measurements you'll need in order to find the correct hubs, and you'll need to use a digital caliper to measure your spindle to the thousandths of an inch where the bearings and grease seal ride, like in the…

It is possible the Fulton Round, Snap-Ring Swivel Marine Jack #FTJ120W0301 will fit the same mount used by your Shelby 5776 jack but we do not have the exact dimensions of the mount used by your Shelby jack so you will need to take a quick…

I went out to the warehouse to take a look at the Yates Spool Roller #YR410Y-4 referenced in your question. The inner portion/axle does indeed run completely through the roller, from one end to the other. The roller measures 4 inches long and 3…

The Single Axle Jeep Style Trailer Fender #HP25VR is going to be the closest we have to the dimensions you are looking for. This fender is 10" wide, 21" long and 8" tall. Our next largest size Fender #HP76VR is going to be…

The Demco Channel Tongue Trailer Coupler #DM15629-52 has a 7-3/4" channel from the back of the coupler to the inside lip near the ball latch.

The code SAE P2 91 DOT on the light lens is the lens rating, not a part number, so it is difficult to go by that number. Often the actual part number for a light will be on the back of the light base or housing. If not, it is usually easiest to go…

From all the photos I saw online, it looks like Floe used grommet mounted 2-1/2 inch marker lights and standard 6-1/2 by 2-1/2 inch oblong taillights. If that's the case, for the amber 2-1/2 inch I would recommend #MCL59AB and #MCL59RB for the…

The best option we can offer you is the Trailer Idler Hub Assembly part #AKIHUB-545-2-EZ-2K which will be a direct replacement for the Dico Trailer Hub Assembly part 45263 so long as you the Double Lip Grease Seals part #RG06-010. The Trailer Idler…