Roof Rack Solution for 2014 Coleman Utah Pop Up

Question

Question:

Do you have a roof rack for a 2001 Coleman Utah pop up camper?

asked by: Norm R

1

Helpful Expert Reply:

We don't have anything custom fit but the Swagman Roamer part # S80510 that you referenced would be a great option for a roof rack for your 2001 Coleman Utah pop up. This fits all pop up roofs and installs with included hardware after drilling through the camper roof.

expert reply by: Jameson C

1

Answer 1

Loadstar ST185/80D13 Bias Trailer Tire #AM3S331 is a bias ply construction whereas the 185/80R13 you have is a radial tire construction. The difference is how the plies run inside the tire. You would want to keep the construction type the same on the…

view full answer...

Answer 2

Hey Tyler, I'm glad everyone was ok with the blowout and nothing serious happened, and to answer your question yes, you can go to 185/80-13 tires as they're just a bit larger than 175/80-13 tires. As for the right one, despite popular…

view full answer...

Answer 3

I took a look in the manual for the Swagman Roamer LT Roof Rack part #S80510 which appears to be what you are using and on page 1 (step 1) it states that before installation you will need to contact the trailer manufacturer to ensure the trailer is…

view full answer...

Answer 4

You did not say whether you have electric or hydraulic brakes on your 2000 Coleman Utah camper. You will need to know a few details when choosing replacement brake assemblies. There should be a plate or sticker on the axle with the weight rating. You…

view full answer...

Answer 5

I do have the needed parts to provide you with a 7-way trailer connector but unfortunately, I don't have any information on the plate/socket you are referring to. The best place to look for advice on this would be in your owner's manual but…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Roof Rack Solution for 2014 Coleman Utah Pop Up

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching