Will Curt Trailer Hitch Receiver for 1984 Chevy C/K Series Pickup Work with Brackets Under Frame
Published 03/09/2023
Question:
I have a 1984 Chevrolet C20, 8 foot bed, 34 wide frame, with the factory installed step bumper on it. The factory bumper has a bracket mounted to the frame which will interfere with any hitch installation. I can send pictures if needed. The hitch that is recommended, the Curt C14082, I dont think will fit because of that bracket. Are there other options I have?
asked by: Travis W
Expert Reply:
The trailer hitch options for a 1984 Chevrolet C/K Series Pickup all install in the same manor using holes on the underside of the frame. If there are any brackets present they would need to be removed and are most likely not factory therefore the hitch is not designed to work with them. I have attached a photo of the Curt Trailer Hitch Receiver part # C14082 close up so you can review fit.
(click to enlarge)
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class IV
- 1000 lbs TW
- 10000 lbs GTW
- 12000 lbs WD GTW
- 2 Inch Hitch
- 1200 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Shop: Draw-Tite Max-E-Loader Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Search Results: 7 pin trailer wiring harness
- Q&A: Side Plate and Bolt Hole Spacing Measurements for Curt Trailer Hitch # C14082
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: 41504
- Search Results: trailer hitch wiring harness
- Search Results: trailer hitch wiring custom fit vehicle wiring
- Shop: Brake Controller
- Video: Install: Draw-Tite Max-E-Loader Trailer Hitch Receiver on a 1978 Chevrolet c/k Series Pickup
- Q&A: Bolt Hole Spacing of Curt Class IV Hitch Receiver 14082
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Trailer Hitch for a 1979 Chevy C-10 with Trailering Special Package
- Q&A: Class V Hitch for 2003 GMC Savanah Cutaway
- Q&A: Curt Trailer Hitch Receiver # C14082 Tube Height From Mounting Flange For 1973 Ford F-100
- Shop: Curt 3-Piece Trailer Hitch Receiver - Multi Fit - Class V - 2"
- Q&A: How Wide is Hitch Mounting Bracket of Curt Hitch part # C14082
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: B&W Heavy-Duty Trailer Hitch Receiver - Custom Fit - Class V - 2"
- Q&A: Distance From Hitch Tube to End of Receiver of Curt Hitch C14082
- Search Results: c14082
- Search Results: 41001
- Search Results: 14082
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Video: Feature Breakdown: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector