Locating Jumper Plug for 7-Way Installation in 2008 Nissan Pathfinder
Updated 01/23/2023 | Published 01/22/2023
Question:
Pulled the panel off my 2008 Nissan Path finder and the jumper plug wasnt there. The pathfinder has a factory install 4 way and well as the factory plug for the electronic break but doesnt have the plug for the jumper?????? what now
asked by: Richard F
Expert Reply:
The # 118266 is designed for a 2008 Nissan Pathfinder without a factory trailer connector. The plug for the jumper will be in the location you described, behind the kick panel on the passenger's side. However, since you already have a factory trailer connector there will already be a jumper in place which means you aren't going to see an open plug. This is probably the reason why you aren't finding it.
This would also mean you have the relays in place. Assuming that is the case, you can plug in the 7-way and you will be ready to go. If not, make sure you are looking at the top of all of the connectors. There should be an open 12-pin connector tucked behind everything to plug the jumper into.
I attached an installation video for your reference. If you watch starting at the 2:50 mark you will see where the connector is located.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Article: Determining Trailer Tongue Weight
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Search Results: curt 17062
- Search Results: sway control
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Q&A: Adding Additional Sway Control To a Reese Pro Round Bar Weight Distribution
- Q&A: Reese Weight Distribution System Recommendation for 1,050 lbs of Tongue Weight
- Q&A: Will Friction Sway Control Stop Swaying Trailer that Already has Weight Distribution
- Q&A: Is Weight Distribution Hitch Or Sway Control Needed For 2019 Toyota 4Runner TRD Pulling RV?
- Q&A: The Difference Between A Weight Distribution System and Weight Distribution System With Sway Control
- Q&A: Can Friction Sway Control Be Added To Small Travel Trailer Without Weight Distribution Hitch?
- Shop: Suspension Enhancement
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Stealth Hitches Hidden Rack Receiver - Custom Fit - 2"
- Q&A: Can You Use Friction Sway Control With A Vehicle That Has Electronic Sway Control?
- Video: Feature Breakdown: Curt Round Bar Weight Distribution System w/ Friction Sway Control
- Video: All About the Curt MV Weight Distribution System
- Shop: Fastway e2 Weight Distribution w/ 2-Point Sway Control - Round - 8,000 lbs GTW, 800 lbs TW
- Shop: etrailer Electric Trailer Jack - Drop Leg - A-Frame - 18" Lift - 3,500 lbs
- Shop: etrailer Electric Trailer Jack - Drop Leg - A-Frame - 18" Lift - 5,000 lbs
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Equal-i-zer Weight Distribution System w/ 4-Point Sway Control - 6,000 lbs GTW, 600 lbs TW
- Article: Trailer Wiring Diagrams
- Search Results: trailer wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Article: How to Measure for Trailer Hitch Drop
- Search Results: trailer tires and wheels
on Custom Fit Vehicle Wiring
