Can You Use Friction Sway Control With A Vehicle That Has Electronic Sway Control?
Updated 07/14/2022 | Published 07/13/2022 >
Products Featured in This Question
Question:
I heard or read that the old tried and true sway bar sway control shouldn't be used when the TV has built-in electronic sway control as they will work against each other. What is the word from the experts?
asked by: Jake L
Expert Reply:
That's correct it's not that it can't be used, it's just that using a friction sway control kit # 83660 with a tow vehicle that already has electronic sway control would not be nearly as effective as a good weight distribution/sway control set-up.
Rather than use both, I recommend picking an affective WD/SC setup like the:
-Equal-i-zer Weight Distribution System w/ 4-Point Sway Control # EQ37100ET.
This system has a tongue weight range of 600-1,000lbs, and has integrated 4-point sway control that limits side to side movement of your trailer.
Once that is figured, you're going to want a system that has your tongue weight in the middle of the tongue weight range.
However, when it comes to picking out the correct WDS, you'll want to take note of your total tongue weight which is your fully loaded, ready-to-go trailer and all additional weight behind your rear axle.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Search Results: curt 17062
- Article: Determining Trailer Tongue Weight
- Search Results: sway control
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Search Results: trailer hitch
- Shop: Trailer Hitch
- Shop: Suspension Enhancement
- Q&A: The Difference Between A Weight Distribution System and Weight Distribution System With Sway Control
- Q&A: Adding Additional Sway Control To a Reese Pro Round Bar Weight Distribution
- Q&A: Can Friction Sway Control Be Added To Small Travel Trailer Without Weight Distribution Hitch?
- Q&A: Reese Weight Distribution System Recommendation for 1,050 lbs of Tongue Weight
- Q&A: Will Friction Sway Control Stop Swaying Trailer that Already has Weight Distribution
- Q&A: Is Weight Distribution Hitch Or Sway Control Needed For 2019 Toyota 4Runner TRD Pulling RV?
- Q&A: Locating Jumper Plug for 7-Way Installation in 2008 Nissan Pathfinder
- Video: All About the Curt MV Weight Distribution System
- Shop: Stealth Hitches Hidden Rack Receiver - Custom Fit - 2"
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: etrailer Electric Trailer Jack - Drop Leg - A-Frame - 18" Lift - 3,500 lbs
- Shop: Fastway e2 Weight Distribution w/ 2-Point Sway Control - Round - 8,000 lbs GTW, 800 lbs TW
- Shop: 2" Hitch Ball - 1-1/4" Diameter x 2-5/8" Long Shank - Chrome - 10,000
- Shop: Air Lift Load Controller Compressor System for Air Helper Springs- Heavy Duty - Dual Path
- Shop: Mounting Bracket and Installation Hardware - Pollak 7-Pole, RV-Style Trailer Connector - Vehicle End
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer wiring
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Search Results: trailer tires and wheels
