Recommended Square Gooseneck Coupler For A 4" Wide Square Tube

Question

Question:

do you know if there is a product similar to a BWTEXA4200 in 4 square extend a goose thanks

asked by: David P

0

Expert Reply:

Similar to the B&W Extend-A-Goose Gooseneck Coupler - 2-5/16" Ball - 10" Offset # BWTEXA4200 is the Shocker Hitch Air Cushioned Gooseneck Coupler # SHK46MR which has a 9" offset, a 4" wide square tube, and has a maximum towing capacity of 30,000-lbs.

This gooseneck coupler has an easy-to-use lockable lever, an adjustable air bag that lets you easily adapt the coupler to match your trailer's load, and is made in the USA.

expert reply by: Bryce D

0

Answer 1

Using an offset coupler depends on the weight capacity. You can absolutely use a 9 inch offset coupler if it can handle the capacity of your 3 car trailer. We do not carry a square offset coupler, so I can't give you the part you are seeking. The…

view full answer...

Answer 2

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 3

Hello Roy, Looking to swap to disc brakes, you will not be disappointed. Pairing that with the Roadmaster Comfort Ride system makes a huge difference in both braking performance and overall ride quality, especially with a fifth wheel like your…

view full answer...

Answer 4

Hey Kevi, it won't be an issue to only use set screws when installing the B and W Extend a Goose part #BWTEXA4200 like what you have currently. Just make sure those set screws are torqued down properly and it will be totally fine. Are you needing…

view full answer...

Answer 5

Hey Peter, for that I would recommend the Firestone Air Command Extreme Duty Compressor and Tank part #F46VV. This has a really heavy duty compressor which means it will inflate a lot quicker and also has a tank that you can use for the air horns as…

view full answer...

Answer 6

As long as your horse trailer features a 4 inch diameter outer tube (which is pretty standard) the B&W Extend-A-Goose Gooseneck Coupler #BWTEXA4200 that you referenced will work really nicely to replace its inner tube. It will provide a 10 inch…

view full answer...

Answer 7

Hey Mike, the B&W Extend-A-Goose Gooseneck Coupler #BWTEXA4200 is going to require a pin hole in the outer tube of your coupler like you mentioned. Could you drill a hole through your current coupler?

view full answer...

Answer 8

Hey Dennis, welcome back! I have a couple of options for you depending on what you mean by flip over ball. If your 2014 Ram 2500's gooseneck ball goes into a square shaped receiver like item #BWGNRK1384, then I highly recommend the B&W…

view full answer...

Recommended Square Gooseneck Coupler For A 4" Wide Square Tube

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching