How To Hook-Up DC Wires/Fuses on Replacement Converter Parallax/Magnetek or WFCO RV Power Centers
Updated 03/09/2026 | Published 10/15/2022
Question:
The DC distribution boards do not match and Im unsure how to proceed with wiring What is the proper fuse placement and wiring for the bottom of the panel? I know how the old panel is wired but the new one has more connector. Attached is a picture of the old board in its original state
asked by: Nathan A
Expert Reply:
In regards to the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part # PD4645V, the fused slots on the control board are very easy to hookup. If you're swapping out an old panel just make sure to label each of the wires before removing. Then, you can connect the old wires into the terminals on the new board with a screwdriver, just make sure you then assign the correct fuse to said wire. It does not matter which slots you places the wires in, just make sure the fuses match said wire from the old board. There could very well be more slots than your old board, they can be left blank and used latter down the road if needed.
That said, it's really best to seek professional installation of the panel or converter section if you need assistance as these should be carried out by a licensed professional .
(click to enlarge)
Product Page this Question was Asked From
Progressive Dynamics Replacement Section for AC/DC Power Distribution Panel - 45 Amp
- Accessories and Parts
- Power Converter
- Converter Section
- 45 Amp
- Progressive Dynamics
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: 8 lug drum
- Shop: Progressive Dynamics Replacement Section for AC/DC Power Distribution Panel - 45 Amp
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: Series 6300A Model 6332 Magnetek Replacement Converter
- Shop: Replacement Section for AC/DC Power Distribution Panel - 35 Amp
- Video: Lippert Toy Hauler Garage Doors Patio Upgrade Kit Review
- Shop: Dexter Trailer Hub and Drum Assembly - 7K E-Z Lube Axle - 8 on 6-1/2 - Pre-Greased - 1/2" Stud
- Shop: Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 7,000 lbs
- Shop: Lippert Patio Upgrade Kit for Toy Hauler Garage Doors - 94" x 94"
- Video: Installing the Progressive Dynamics Replacement Section in a 2012 Casita Spirit Travel Trailer
- Q&A: Recommended Replacement For A MagneTek 6345A Power Center Converter
- Q&A: Replacement Converter for 45 Amp Magnetek 6345
- Shop: Karrier KR03 ST225/75R15 Radial Trailer Tire - Load Range C
- Q&A: Recommended Wheel and Tire Size for a 2,000 Lb Trailer Axle
- Q&A: Best Trailer Tire Recommendation for Size ST225/75R15
- Shop: Karrier KR03 ST225/75R15 Radial Trailer Tire - Load Range E
- Video: Review of Victron Solar Charge Controllers - BlueSolar Solar Charge Controller 15A 75V - VN28ZR
- Q&A: How To Wire In The DC Side Of The Progressive Dynamics PD4135K Power Center
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Search Results: trailer tires and wheels
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer wiring
- Article: How to Measure for Trailer Hitch Drop
- Shop: Suspension Enhancement
- Video: Measuring To Choose The Right Trailer Axle
- Search Results: trailer jack
- Shop: Brake Controller
on Accessories and Parts
Pamela
3/8/2026
On the top of fuse board their a blue line were do I connect it to