Trailer Wiring Harness For A 2013 Toyota Venza
Updated 09/10/2022 | Published 09/09/2022
Products Featured in This Question
Question:
My wiring module on my 2013 Venza is bad, can I just replace the module?
asked by: Jerry O
0
Expert Reply:
Though you can not replace the module only on your wiring harness on your 2013 Toyota Venza, I do recommend replacing the harness with The Curt T-Connector Vehicle Wiring Harness # C56079.
This harness will plug into your vehicle's wiring harness, which is located behind the driver's-side and passenger's-side interior trim panels in your rear cargo area.
I attached an installation video link below.
expert reply by:
Noah E
0
Product Page this Question was Asked From
Loadstar ST205/75D14 Bias Trailer Tire with 14" White Wheel - 5 on 4-1/2 - Load Range C
- Trailer Tires and Wheels
- Tire with Wheel
- Bias Ply Tire
- Load Range C
- 205/75-14
- 14 Inch
- K - 65 mph
- 5 on 4-1/2 Inch
- Steel Wheels - Powder Coat
- Kenda
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Replacement Tires For Utility Trailer That Uses ST205/75D14
- Q&A: Difference Between Trailer Tires ST205/75D14 and ST205/75R14
- Q&A: Replacement Hub for Trailer with 84 Spindle Dimensions
- Q&A: Diameter of Outside Center Hub Bore for Dexter 3,500 lb Idler Hub # 84655UC1
- Q&A: Pilot Hole Diameter to Fit Dexter Hub and Drum for 3,500 Pound Axle with 5 on 4-1/2 Bolt Pattern
- Q&A: Recommended Bearings and Hubs for 3500 lb Square Axle Trailer Spindle
- Q&A: Proper Centering of New Trailer Wheel Whose Pilot Hole is Larger Than Original Wheels
- Article: Trailer Tire Sizing
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class