Half Kit of CJ31 1,000 lb 57" Lift Brophy Cable Camper Jacks

Question

Question:

Is the following item available as a single, not as a pair? Brophy Cable Camper Jacks - 57 Max Lift Height - 1,000 lbs - Qty 2 Item # CJ31

asked by: Dan D

0

Expert Reply:

We do have a half kit (or single jack) of the Brophy Cable Camper Jacks - 57" Max Lift Height - 1,000 lbs # CJ31 you referenced. This is found as part # BR29ZR on our site.

expert reply by: Jon G

0

Answer 1

I spoke with my contact at Brophy and they stated you'll be fine using the Brophy Clamp On Camper Tie-Downs - Bed Mount - Black Powder Coated Steel - Qty 4 Item #HSWB as long as the railing on the back of your 2008 Chevy Silverado isn't over…

view full answer...

Answer 2

Unfortunately the deployable running boards are going to prevent the installation of TorkLift camper tie-downs so the only other option would be Brophy Clamp On Camper Tie-Downs #HSAB. These tie-downs clamp to the inner lip of the bedrails and angle…

view full answer...

Answer 3

Hello Brian, thanks for reaching out. With the Brophy Cable Camper Jacks #CJ74, the L-bracket sits about 3" out from the edge of the jack tube. So it doesn't give you a whole lot of extra clearance. It will only work on setups where you have…

view full answer...

Answer 4

We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is approximately…

view full answer...

Answer 5

The Brophy Cable Camper Jacks part #CJ74 can be used for storage but if the side of the camper do not extend to or past the sides of the truck bed it would not be feasible for them to be used for loading/unloading. That said, you could somehow…

view full answer...

Answer 6

I would be happy to help! The only difference between the Brophy Cable Camper Jacks #CJ31 and #CJ41 is the weight capacity. The #CJ31 has a 1000lb weight capacity where the #CJ41 has a 3000lb capacity. Both have the same 17" - 57" lift…

view full answer...

Answer 7

Thanks for the photo and that model of Happijac is nearing a quarter-century old as of this writing and there are no longer replacement parts available for it. The best option we can offer are new camper jacks, the Brophy Cable Camper Jacks and you…

view full answer...

Answer 8

You should not have a problem with the camper sliding out when you are using any of the Brophy Cable Camper Jacks. The jack is very stable because of the tripod base. That stability will make the jack very difficult to tip to the front or the back.…

view full answer...

Answer 9

The Brophy Camper Tie Downs, part #TDSF can be used on campers that have a total length of up to 8 feet in length. The Brophy Camper Tie Downs, part #HSSF can be used on any size campers. There is no weight capacity rating on the camper tie downs and…

view full answer...

Half Kit of CJ31 1,000 lb 57" Lift Brophy Cable Camper Jacks

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching