Can I Use Brophy Camper Jacks to Lift a Truck Cap Off My Pickup for Storage?
Updated 06/03/2026 | Published 05/27/2026 >
Products Featured in This Question
Question:
I have an ARC truck cap that I want to be able to lift off my truck, store in a garage, and put back on when needed. The cap weighs about 200 lbs. Can I use the Brophy camper jacks for this purpose?
asked by: Grace L
Expert Reply:
Hey Grace, thanks for reaching out!
The Brophy Camper Jacks # CJ31 has a 1,000 lb weight capacity for the pair, they can easily handle a cap that weighs around 200 lbs.
The main thing you'll want to check is that there is enough room for the jack brackets and uprights to fit around the sides of the cap while it's still mounted on the truck. As long as the body of the truck does not stick out more than 3" it will not obstruct the upright portion of the jack.
You lastly want to make sure there is adequate clearance, so the jacks can be raise the cap high enough for you to drive the truck out from underneath it.
Will you be storing the cap for short periods or long-term in the garage?

Edward
6/3/2026
What I do is place 2 or 3 8 ft 2x6 boards between camper and truck box and then it's safely resting on these. Just lower down to bottom while storing and maybe Brace corners with wooden blocks on ground. And remove and store jacks out of weather to maintain their performance.


Jeff
6/3/2026
I bought the jacks to remove a pop up camper off a 1970 ford two wheel drive pick up. The camper over hangs the side of truck bed I a good bit, which the jacks facilitate ok. Even then the legs of the jacks sit right next to the tires, and make it a bit nerve racking. On a camper shell the shell sits very flush with the side of the truck, often narrower the the actual side of the bed. I don’t think the small shelf of the angle iron will accommodate a shell, safely. I made a pulley system years back to remove a shell from my truck. Placed two by fours under the shell, left them sticking out the side a bit, enough to drill eye bolts, nuts and washers. Then made a rope harness too the ceiling of the garage, with a boat crank mounted to the wall. I could lift it just far enough to drive out from under it. Or crank it up to the ceiling, to store it for longer periods of time.
Product Page this Question was Asked From
Brophy Cable Camper Jacks - 57" Max Lift Height - 1,000 lbs - Qty 2
- Camper Jacks
- Truck Camper
- Tripod Jacks
- Steel
- 1001 - 2000 lbs
- Manual Jack
- 57 Inch Lift
- 2 Jacks
- Brophy
more information >
Continue Researching
- Shop: Brophy Cable Camper Jacks - 57" Max Lift Height - 1,000 lbs - Qty 2
- Video: All You Need to Know About the Brophy Cable Camper Jacks
- Video: The Low-Down on the Brophy Cable Camper Jacks
- Shop: Brophy Cable Camper Jacks - 67" Max Lift Height - 3,000 lbs - Qty 2
- Shop: Brophy Cable Camper Jacks - 57" Max Lift Height - 3,000 lbs - Qty 2
- Shop: Brophy Cable Camper Jack - 67" Max Lift Height - 1,500 lbs - Qty 1
- Q&A: Replacement for Older Happijac Truck Bed Camper Jack
- Video: Ultimate Overview of the Brophy Cable Camper Jack
- Shop: Brophy Heavy Duty Cable Camper Jacks - 67" Max Lift Height - 4,000 lbs - Qty 2
- Q&A: Can Brophy Camper Jacks be Used with Dually Truck
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Q&A: Diameter of Tripod Base for Brophy Cable Camper Jacks
- Q&A: Solution for Truck Bed Camper Jacks with Bad Gears
- Video: Brophy Cable Camper Jacks Manufacturer Discussion
- Shop: HappiJac Extender Bracket for Dual Wheel Chassis Truck Camper Jacks - Qty 1
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Shop: Trailer Hitch
- Video: A Look at the Power Mountain Tallboy 6 Ton Off-Road Bottle Jack with a Military Cargo Trailer
- Shop: Trailer Wiring
- Q&A: Which is Better Roadmaster or Blue Ox Tow Bar
- Search Results: trailer tires and wheels
- Article: How to Measure for Trailer Hitch Drop
- Shop: Suspension Enhancement
- Video: An In-Depth Look at the Roadmaster Battery Charge Line Kit for Towed Vehicles
- Q&A: Parts Needed to Install a Red Arc Brake Controller in a 2023 Toyota Tacoma
- Article: 5 Things to Know About Weight Distribution Hitches
- Search Results: trailer wiring
- Video: Redarc Tow-Pro Liberty Brake Controller Review RED24FR


Rustin
6/3/2026
I bought the jacks to help remove the cap (300lb) from my Ford F-150. To give the jacks the needed clearance, I bolted 8" wide 3/4" plywood to the supporting angle iron on each jack. I've got some pics if you want. My intent is to be able to get the cap on and off by myself. First try, I got it off without breaking anything. The jacks seemed stable with the cap on it. They aren't cheap but will never wear out.