Why Does The Replacement Velcro Shur-Bond Fastener for TruXedo Deuce Tonneau Covers Have 4 Strips?

Question

Question:

why is there 4 strips instead of 2?

asked by: Jerry H

0

Expert Reply:

The Replacement Velcro Shur-Bond Fastener for TruXedo Deuce Tonneau Covers for 6' Beds # TX1117786 comes with 4 strips as the Deuce Tonneau has the front section that folds back. This is a feature exclusive to the Deuce cover that allows for access to items in the front of the truck bed.

expert reply by: Bud M

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 3

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 4

Hey Rob, thanks for the information. I have a couple of options for you depending on what TruXdeo soft roll-up tonneau cover you have installed on your 2003 Ford F-250 with a 6-3/4' bed. These attach at the very end of the tonneau cover near the…

view full answer...

Answer 5

If you have the 8' bed then you can go with Replacement Truxedo Shur-Bond Velcro Brand Fastener for 8' Beds - 1" Width #TX1117877. If you have the 6-1/2' bed then you will want to go with Replacement TruXedo Shur-Bond Hook-And-Loop…

view full answer...

Answer 6

There is one rivet on each side rail that holds the existing Velcro strips in place. In order to replace these Velcro strips you need to drill out each rivet, pull the strips out from the channels, slide the new strips (Replacement TruXedo Shur-Bond…

view full answer...

Answer 7

There are a couple of different models of TruXedo soft roll-up tonneau covers that fit your 2007 Dodge Ram 1500 short bed. All of them are shown on the linked page. If your cover happens to mount on top of the bed rails (rather than inside them) as…

view full answer...

Answer 8

I believe we can narrow this down based on the information you are referencing. However, the best way to be sure is to measure your existing bearings or spindle with a digital caliper like the #PTW80157. It looks like one bearing is stamped with…

view full answer...

Answer 9

Hi Johnny! The 1-5/16" Replacement TruXedo Shur-Bond Fastener #TX1115174 is the one you need. The 1-5/16" measurement is the overall width of the plastic backing that slides into the rail, rather than just the hook-and-loop portion…

view full answer...

Answer 10

We currently have a 1-1/4" Wide #TX1115173 and 1" Wide #TX1117877 Velcro strip for tonneau covers. These are the closest we have to the 1-1/8" measurement you have. These are both 8' long as they can be trimmed down to fit your…

view full answer...

Why Does The Replacement Velcro Shur-Bond Fastener for TruXedo Deuce Tonneau Covers Have 4 Strips?

Product Page this Question was Asked From

Continue Researching