Replacement Head and Hardware for a Fastway e2 Weight Distribution System

Updated 05/03/2022 | Published 04/30/2022

Products Featured in This Question

Fastway e2 Weight Distribution w/ 2-Point Sway Control - Trunnion - 10,000 lbs GTW, 1,000 lbs TW

(170)

$650.00

Replacement Head for Fastway e2 Weight Distribution Systems - Trunnion Bar

(32)

$253.06

Replacement Hardware Kit for Fastway e2 Weight Distribution Head - Round and Trunnion Bar

(78)

$50.94

Spacer Washer for Fastway e2 Weight Distribution Head - Qty 1

(64)

$4.80

Question:

Having some problems with my hitch 92-00-100 - on trunnion. The head is still in pretty good shape, but I cant keep the angle adjustment tight. Somehow the original spacers managed to fall out and the pin was damaged. Ive substituted the spacers with washers and using a bolt same size to replace the pin. Despite everything else being correct, I cannot stop the angle from moving? My questions is, is that just an inherent problem with this design, or could I gain control again by replacing the head and hardware? Im looking at replacement head FA92-00-1000 and hardware kit FA92-02-9600. Any help you could provide would certainly be appreciated! Thanks

asked by: Rick M

Expert Reply:

From the issues you described having with your Fastway e2 Weight Distribution # FA92-00-1000 system, replacing the head and hardware is the correct route to take to fix your problems. The outside of your head may be in good shape, but it sounds likely that the inside where the retaining pin and washers sit is damaged.

- Replacement Head for Fastway e2 Weight Distribution Systems # FA92-02-1255

- Replacement Hardware Kit for Fastway e2 Weight Distribution Head # FA92-02-9600

- Spacer Washer for Fastway e2 Weight Distribution Head # FA92-04-9655

expert reply by: Scott S