Power Drill Socket Adapter To Quickly Raise And Lower Leveling Jacks

Question

Question:

Do u make the drill bit attachment for ram 10000 to 12000 square jack? So I can power lift the heavy duty jack quickly.

asked by: James K

0

Expert Reply:

A drill bit attachment like the Ultra-Fab Speed Socket Power Drill Adapter for Scissor Jacks # UF48-979005 is not available for the Square Direct Weld Jack # TJD-12000SP-F2 or # TJD-15000SP-F.

This would only work on scissor jacks like the Leveling Scissor Jack Set # JSC-24 which can utilize the adapter # UF48-979005.

Instead, you could use the Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity # BD1824200100 to convert a manual jack to electric. This will eliminate the need for a socket adapter for a power drill.

expert reply by: Bryce D

0

Answer 1

You'd just have to physically go out to your trailer and measure the angle. So to do this, you'd need to get a protractor or something similar and place it on the edge of the inside on one side of the trailer frame, and check to see if the…

view full answer...

Answer 2

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 3

Thank you for the photos and sorry to hear about your truck! The unique design of the B&W Tow & Stow 2-Ball Mount - Compatible with GM MultiPro Tailgate #BWTS20066BMP is that angled section that meets with the shank part of the ball mount. On…

view full answer...

Answer 4

Yes, the perfect solution for you is the B&W Tow & Stow 2-Ball Mount #BWTS20066BMP, which is specifically designed to work with the GM MultiPro Tailgate. As you can see int the attached photo, the angled design provides clearance for the…

view full answer...

Answer 5

Basically, the difference between Bulldog jack #BD183416 and #BD183816 is the plunger. On the first one, #BD183416, it has a non-spring return plunger. This means that when you pull out the pin to drop or raise the leg, you have to manually re-insert…

view full answer...

Answer 6

Send me the pictures you have and I'll see if it's something we can get.

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Power Drill Socket Adapter To Quickly Raise And Lower Leveling Jacks

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching