Availability of Dutton-Lainson Hand Winch 15440

Question

Question:

Is the Dutton Lainson 15440 still available? I was told it is out of production. I am looking for a budget friendly winch for use with shore cables on a floating dock. The largest capacity for 3/8 galvanized cable would be very helpful. Thanks

asked by: Terry R

0

Expert Reply:

Hey Terry! It looks like there is a little delay on when it will be back in stock but the Dutton-Lainson Hand Winch # DL15440 is still around as far as I can tell. We don't have any notes on this winch being discontinued. The # DL14881 is available right now and has a slightly higher capacity at 3,500 lbs and can hold 37' of 3/8" cable. However, the cost is a bit higher when compared to the # DL15440.

What lake are you on?

expert reply by: Robin H

0

Dutton-Lainson 15440
(click to enlarge)

R C.

3/6/2026

Hi Terry. The Dutton-Lainson Hand Winch's are a quality unit for sure. I installed one on my 20 ft Shamrock that i just outfitted. The trailer is a Bunk style which takes a quit of bit of pull to put her on the trailer. The two speed hand winch is strong and works excellent. RC

Joel

3/6/2026

Terry - I purchased this product last summer to replace the winch for my 20’ 1989 Cobalt boat trailer. It was easy to install and was very please with the smooth operation. I would recommend.

Answer 1

Yes, the Dutton-Lainson Hand Winch with TUFFPLATE Finish, #DL15440, would be a great winch for a boat trailer, especially a larger boat. The TUFFPLATE Finish makes the winch acceptable for marine use and the two speed gearing will help winch the boat…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 12

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Availability of Dutton-Lainson Hand Winch 15440

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching