Speed Rating of Kenda 5.30-12 Bias Trailer Tire with 12" Galvanized Wheel

Question

Question:

I dont see a speed rating listed on your Kenda Tires #AM30790. Was wondering what it was.

asked by: Jonathan W

0

Expert Reply:

The speed rating of the Kenda 5.30-12 Bias Trailer Tire with 12" Galvanized Wheel part # AM30790 is 65 mph. That's pretty much the max for a bias ply tire this size but if you switch to a radial like the Taskmaster 5.30R12 Radial Trailer Tire part # TT53012C you can get up to 81 mph. You will have to add the wheel separate though, it's the Steel Spoke Trailer Wheel part # AM20124.

expert reply by: Conner L

0

Answer 1

For smaller tire sizes like the 4.80-8 that you mentioned the highest speed rating we have is 65 mph like the part #AM10002. This is in part due to the smaller diameter of the tire which means it will be spinning more revolutions at the same speed as…

view full answer...

Answer 2

The Taskmaster 4.80-12 Bias Trailer Tire #TT48012C is our most economical tire that has a speed rating above 70mph. It is rated for up to 81mph and has a class C load rating of 990lbs at 90psi.

view full answer...

Answer 3

The 13 and 12 in the tires sizes indicates that one fits a 13 inch wheel and one fits a 12 inch so they are not compatible with each other. You need a properly sized tire. The closest match we are going to have is a 175/80-13 trailer tire. You will…

view full answer...

Answer 4

I have attached a chart you can check out that describes the torque needed per wheel size, wheel stud size and material. For an 8-inch wheel with a 1/2-inch wheel stud the torque is 75 to 86 ft-lbs. For a 15 inch steel wheel with 1/2 inch wheel studs…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Speed Rating of Kenda 5.30-12 Bias Trailer Tire with 12" Galvanized Wheel

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching