Dimensions of Longview Custom Towing Mirrors for Chevy Colorado

Question

Question:

What are the dimensions of this product, especially the mirror extenstion?

asked by: Terry P

1

Helpful Expert Reply:

I have attached a diagram of the Longview Custom Towing Mirrors Driver and Passenger Side item # LV97RR dimensions. The actual mirror is 4 1/2" x 5 1/2".

expert reply by: Jerred H

1

colorado tow mirrors
(click to enlarge)

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

The CIPA Custom Towing Mirror - Driver Side #10801 that you referenced (which is also available in a set with part #CM10800) is confirmed to fit the following vehicles: 2002 - 2006 Chevrolet Avalanche 2000 - 2006 Cadillac Escalade 2002 - 2006…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…

view full answer...

Answer 9

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 10

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 11

Hey Greg, we have just what you are looking for with the CE Smith idler hub part #CE13515. This is a pre-greased 3,500 lb axle hub that is galvanized like you are looking for. What trailer is this going on?

view full answer...

Answer 12

Hello David, We do have them listed already. You will want their part number 80960, which is our part K-Source Snap & Zap Custom Towing Mirrors - Snap On - Driver and Passenger Side #KS53NQ. These will be a great fit for your 2023 Chevrolet…

view full answer...

Dimensions of Longview Custom Towing Mirrors for Chevy Colorado

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching