Best Trailer Brake Controller For 2022 Chevy Traverse

Question

Question:

What is the best brake controller for a 2022 Traverse?

asked by: James S

0

Expert Reply:

I highly recommend the Redarc Tow-Pro Liberty Brake Controller Universal Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers # RED24FR. It is a permanent install and will be all hidden, save for they small control knob.

You will need a universal wiring harness # RED69FR because the # RED24FR does not come with a wire harness

If you do not want to deal with a permanent install you can go with the Curt Echo Wireless Trailer Brake Controller - 1 to 2 Axles - Proportional # C51180. This is a plug and play that you can control from your mobile device and can be removed and put in your glove box while not in use..

If you do not have a 7-way plug at the back of your vehicle you can get one with the Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires # ETBC7

expert reply by: David B

0

Answer 1

If your 2021 Chevy Traverse has the factory tow package then it can tow up to 5,000lbs according to the online version of the owner's manual (I recommend checking your manual to verify). GM normally offers a more expensive hitch for the factory…

view full answer...

Answer 2

Hey Dave, I would be more than happy to share my opinion on your set up and offer a couple recommendations. I looked up your 2019 Chevrolet Traverse High Country and it's got a maximum towing capacity of 5,000 lbs. This would be a great tow…

view full answer...

Answer 3

Hi Motty, 2021 Chevy Traverse's have a factory connector at the back to plug into so you can go with either a 4-pole #C56394 or 7-way #C56393 connector depending on your needs. Personally, I'd go with the 7-way and if you need to connect to a…

view full answer...

Answer 4

It sounds like you might be looking to tow a trailer with brakes using a 2020 Chevrolet Traverse. If that is the case then I have some great options. That said, there are no wiring adapters for the brake controller which is why I recommend the Curt…

view full answer...

Answer 5

If you are looking at upgrading to a 2022 Chevy Traverse specifically so you can start towing a camper, I highly recommend going with the aftermarket set up. Not only will this be quite a bit less expensive, these will tend to be longer lived than…

view full answer...

Answer 6

The best place to mount a brake controller like the Tekonsha Voyager #39510 is under the driver's side dash in a place so that it is within easy reach in the even that you need to activate the manual override. Technically it could be mounted to…

view full answer...

Answer 7

There is not a vehicle specific adapter for your 2022 Chevrolet Traverse, so you will need to use the universal harness #C27JR. In order to complete installation of the Curt Echo Wireless #C51180, you'll need to add a 7 way #ETBC7L, if you do not…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Best Trailer Brake Controller For 2022 Chevy Traverse

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching