Where to Install Brake Controller on a 2015 Chevy Silverado 1500

Question

Question:

Best place to mount in 2015 Silverado can it be mounted on floor

asked by: Kenny W

0

Expert Reply:

The best place to mount a brake controller like the Tekonsha Voyager # 39510 is under the driver's side dash in a place so that it is within easy reach in the even that you need to activate the manual override. Technically it could be mounted to the floor but since that will be a little out of reach I recommend to the right of your dash under the steering wheel as you can see from the attached photo. This helps to keep it out of the way especially when getting in and out of your vehicle. For your 2015 Chevy Silverado 1500 you will just need to connect the adapter # 3016 under your dash to complete the installation (see attached video).

If you would rather go with a brake controller that is more flexible in where it can install I recommend the Redarc Tow-Pro Elite # RED44FR. Since the main unit doesn't have to be installed in any special place you can literally mount the control knob anywhere within reach on your 2015 Silverado. You can even use the Universal Mounting Panel # 331-TPSI-001 for a clean OEM look (see attached photo). To connect this to your pickup you just need the adapter # 3016-S. You will install the adapter in the same place as mentioned above and you can refer to the linked review video and installation instructions for more info.

expert reply by: Jon G

0

click to enlarge

Answer 1

Hello Greg, Great question, and yes level towing is important. The average height for a mid-size to full-size travel trailer is 22 to 28 inches, the average height for an F-350 with 4 wheel drive is 20–24 inches, with that being said you will most…

view full answer...

Answer 2

Hello Dan, thanks for reaching out. The best way to add a 7-way and brake controller to your 2017 Hyundai Santa Fe with an aftermarket 4-pin is by using the Universal Installation Kit #ETBC7. This kit contains everything you need to upgrade the…

view full answer...

Answer 3

To determine the correct brakes for your trailer we'll need to first know the axle capacity. The Dexter Electric Trailer Brake Kit #23-26-27 you were looking at are designed for 3,500lb axles. From there you'll need a hub/drum assembly, which…

view full answer...

Answer 4

I have attached a basic brake controller wiring diagram for you. You will want to make sure that you ground the white wire to the negative post on the battery. The black wire will attach to the positive battery post. The red wire will tap into the…

view full answer...

Answer 5

According to my research, your 2017 Subaru Outback Wagon has a max towing capacity of 1,000 lbs if the trailer does not have brakes or 2,700 lbs if the trailer does have brakes. You can improve the towing performance/efficiency of your vehicle with a…

view full answer...

Answer 6

The factory brake controller connector under the dash is not all that visible but it is fairly easy to locate. It is a 4-pin connector that is located underneath and left of the steering column. It will be taped to another harness near the brake…

view full answer...

Answer 7

If the trailer's momentum is causing you some white-knuckle driving, then I would agree that it is time for a brake controller on your 1998 Ford Ranger. Since you already have the 7-Way installed you will just need to finish off the connections…

view full answer...

Where to Install Brake Controller on a 2015 Chevy Silverado 1500

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching