Replacement Landing Gear Motor and Gear Box For Model 1-065-041012-0 On 2009 Keystone Montana

Question

Question:

Have a 09 keystone montana and the front jack motor is going out. The motor says Model 1-065-041012-01 12VDC 3.1A 7140 RPM. Want to replace with equivalent or better. Want to replace all gear and motor parts without changing actual jack system.

asked by: Kyle J

0

Expert Reply:

I would be happy to make a recommendation for you!

To replace the 1-065-041012-01 motor on your 2009 Keystone Montana I recommend the Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor # LC141893 which has the same 7140RPM speed, and for replacement gears I recommend the Replacement Aluminum Gearbox for Stromberg Carlson Landing Gear # LG-179015 which uses an aluminum case making it quite a bit stronger than the factory gearbox with a plastic case.

I included videos of the products mentioned for you to take a look at.

expert reply by: Samuel C

0

Answer 1

Lippert was unable to identify exactly what you have based on part numbers, but I can still help you find the correct replacement. You will need to check and see where the landing gear is mounted and also measure the black outer tube on your existing…

view full answer...

Answer 2

The correct replacement for your 1-065-041012-01 motor is part #LC141893 from Lippert. Your original motor had a 7140 rpm speed. The Stromberg-Carlson #LG-196308 you specified has a 5430 rpm output, so it wouldn't be a good choice. You'll…

view full answer...

Answer 3

I attached a wiring diagram for the Solera Power Awning Switch Kit #LC285500 for you to check out.

view full answer...

Answer 4

Hey Michael, so based on what you mentioned it sounds like you have a standard Lippert/Venture/LCI style landing gear and you have the 5,500 RPM motor. We do have a higher RPM motor that you can replace it with with the part #LC141893 which turns…

view full answer...

Answer 5

Your Raptor Toy Hauler likely has a landing gear setup similar to the one you were looking at: Lippert Electric Landing Gear Set - Weld On - 37" Lift - 6,000 lbs #LC333964. If so, then the correct replacement motor would be Lippert Components…

view full answer...

Answer 6

We do have the correct replacement for your Atwood 71119 landing gear motor, which is what is shown in your photo. The replacement part is the Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor #LC141893. I have added a link to a…

view full answer...

Answer 7

Hey Johnny, thanks for reaching out! I highly recommend using the Lippert HD 6500-lbTuson 5th Wheel RV Landing Gear Motor #LC196308 as a replacement for your 8532-07 motor. According to my research your motor is rated for 5,500 lbs so this motor will…

view full answer...

Answer 8

Given the issue you described and the fact that you have done a good job of troubleshooting and checking other potential sources for the issue, it sounds like the motor is going bad. Since you mentioned the landing gear working fine for a little bit…

view full answer...

Answer 9

We have just what you need to replace your landing gear motor M9000PK with the #LC196308 and you'd be set! This is a confirmed fit for what you have and is a faster motor too so your jacks will raise and lower quicker.

view full answer...