Are Tri-Bar LED RV Tail Light Surface Mount or Flush Mount
Updated 01/15/2021 | Published 01/13/2021
Question:
In one part of the description you have surface mount but in another it says flush mount so the question is which one is it? Do you have to do a hole in the RV to fit them in or do you screw it on the surface? Yes I understand that a hole must exist for the wires to go through but other than that any other holes?
asked by: Carlos
0
Expert Reply:
I checked with the manufacturer, and the Optronics Tri-Bar LED RV Tail Light is indeed flush-mounted. The correct part number is the following:
- Tri-Bar LED RV Tail Light # OPT27FR
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Tri-Bar LED RV Tail Light - Stop, Tail, Turn - Submersible - 33 Diodes - Passenger's Side
- Trailer Lights
- Tail Lights
- Stop
- Tail
- Turn
- Recessed Mount
- Submersible Lights
- LED Light
- 21-7/8L x 12-7/8W Inch
- Amber
- Red
- Optronics
more information >
Continue Researching
- Q&A: Are The B&B Top Rear Corner Trim For RV Seam Left Hand BM25ZR And Right Hand BM52ZR The Same Size?
- Q&A: Best Way to Install a Recessed 4 Inch Round Tail Light on a Trailer
- Q&A: How Do the Cables Get Mounted To the Doors On the Conventional Ramp Door Springs
- Q&A: Replacement Rear Cam Door Lock Recommendation for a 2012 Voltage 3900
- Q&A: How to Correctly Position Ramp Door Spring for Installation
- Q&A: Mounting Hole Dimensions for the 55" Lock Side-Door Bar Lock Assembly # 3057-55
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Trailer Hitch Receiver and Wiring for 2025 Subaru Forester Towing Trailer
- Article: Trailer Lighting Requirements
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)