Distance From Pipe Mount to Bottom of Trailer Valet JX Trailer Jack When Retracted

Question

Question:

What would the distance from the hole where the trailer would connect to the bottom of the jack while fully compressed would be?

asked by: Gwen M

0

Expert Reply:

Hey Gwen! The distance from the center of the mounting hole to the bottom of the Trailer Valet JX Trailer Jack # TV35FR when fully retracted is 13.44". If you’re measuring from the bottom of the pipe mount instead of the center of the hole, that distance is 12.67" See the attached photo with the full dimensions.

What kind of trailer will you be installing the jack on?

expert reply by: Robin H

0

TV35FR Dimensions
(click to enlarge)

Answer 1

Hey Anthony! The outer diameter of the weld-on pipe coupling on the Trailer Valet JX Trailer Jack #TV35FR is 2.01". I went ahead and attached some dimensional drawings below for your reference. What kind of trailer do you have?

view full answer...

Answer 2

No worries Lorelei, I'm here to help! Very nice name by the way; I've never met a Lorelei. You probably can't say the same about my name though haha. Anyways, an electric jack is more of an upright only jack, whereas the manual options…

view full answer...

Answer 3

Hey Denver, yes a driver can be used to raise and lower the Trailer Valet JX Trailer Jack #TV35FR instead of a drill. Do you more often than not have a driver on you instead of an electric drill?

view full answer...

Answer 4

Hey Ashley, thanks for the information! To replace a Atwood 85778 brake actuator, I recommend the Demco Hydraulic Brake Actuator item #DM62VR for drum brakes. It has the same 2" ball size and offers a bolt-on install for a 3" wide straight…

view full answer...

Answer 5

Hey Robert, thanks for the information. To add rear stabilizer jacks to your dump trailer, I recommend a pair of the Square Direct Weld Jack w/ Footplate item #TJD-8000S. This jack has a 7,000 lbs capacity and is sold individually so you'll need…

view full answer...

Answer 6

Hello Evan, thanks for reaching out. Sadly, the Round, Pipe Mount Swivel Jack #TJP-5001S-B does not have any kind of provision for operating with a drill. For that jack it will be the hand crank only. If you are looking for a jack that can be…

view full answer...

Answer 7

If you want a sidewind jack with a drill power option, you are looking at the Trailer Valet JXC/JXS #TV34FR or #TV64FR. The only problem here is these only have 14" of travel and they are not a pipe mount. These are currently the only sidewind…

view full answer...

Answer 8

The Trailer Valet #TV64FR JXS 5K trailer jack is a pipe mount swivel jack that can be removed from the trailer by pulling the pin shown in the provided photo. If you click the provided link, you can see a video showing a typical installation.

view full answer...

Distance From Pipe Mount to Bottom of Trailer Valet JX Trailer Jack When Retracted

Product Page this Question was Asked From

Continue Researching