Do Fulton Jacks Have Their Size and Other Specs Listed on the Spec Sticker

Updated 01/06/2021 | Published 01/02/2021

Products Featured in This Question

Fulton F2 Swing-Up, Wide-Track Trailer Jack, 8" Single Wheel, Sidewind, Bolt-On - 1,600 lbs

(200)

$266.10

Question:

I have a Fulton jack on my boat trailer that is too long. Can’t let jack down when attached to my boat so I have to use floor jack to unhitch my boat. Are the lengths/sizes of jack bolt area to floor stamped/printed anywhere on the Fulton

asked by: Roger C

Expert Reply:

There typically isn't going to be that type of information on a jack, but if you can find a part number somewhere you'll likely be able to find that information by cross referencing it on our site or another. With that said, it sound like you likely need something shorter. I recommend using a jack like the Fulton F2 Swing-Up Trailer Jack part # F1413140334 , which is designed for trailers with a 3" x 4" or 3 x 5" tongue. If you have a 3" x 3" or 3" x 4" tongue then you will need to use the Fulton F2 Swing-Up Trailer Jack part # F1413040134. Both of these jacks have roughly 10" from the bottom of the wheel to the bottom of the jack tube, so they're extremely compact and sound like they'd be a good fit for your boat without knowing any dimensions.

If you'd like, you can send me some dimensions of your current jack and I'm happy to confirm one of these would work or look for an alternate solution. I've also linked a review video for you to check out.

expert reply by: Erik B