Does Bargman 47-84-527 LED Trailer Taillight Have a Rubber Base

Question

Question:

Hello, Thinking about the your taillights part # 47-84-527 for my 69 dunebuggy. My question is ,is the black base flexible rubber?

asked by: Tim F

0

Expert Reply:

The base or bezel used by the Bargman # 47-84-527 Double LED tailllight is constructed of hard plastic, like the other rectangular lamps of this type. If you click the provided links, you can see a product demonstration and an install video.

For something with a flexible rubber mount, you'd be wanting a grommet mount lamp, like # STL70RB which would mount using the separately available # A70GB which would mount in a 6-11/16 x 2-5/8 inch rough opening and would use a # A45PB 3 prong plug.

expert reply by: Mike L

0

Answer 1

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

Hi Kyler! We definitely have center caps and lug nuts that you can use, but the Kenda Karrier KR35 ST175/80R13 LRD Radial Trailer Tire w/ 13" Aluminum AM03 Wheel - 5 on 4-1/2 #KE34TJ does not include them. With that said, I recommend the…

view full answer...

Answer 8

Hey Dave, for a saltwater boat trailer, powder-coated wheels wouldn't be my first choice, but they can still last quite a while if you're good about rinsing them thoroughly after each launch and sealing any chips or cracks in the finish as…

view full answer...

Answer 9

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 10

The 5 means that the wheel is 5 inches wide from bead to bead (not overall width). The J indicates the design of the wheel bead seat but it is nothing you need to be concerned with as this is the most common shape for all trailer tires. To measure…

view full answer...

Answer 11

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Does Bargman 47-84-527 LED Trailer Taillight Have a Rubber Base

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching