Search: breakaway battery   >  

Well Steve, the only way for me to see exactly what brakes your trailer came with is by getting the serial number for each axle. I would say your trailer is most likely going to have 3,500lbs axles which would use a 10" brake like our…

Unfortunately Steve, I have no way to see exactly what lights came on your 2003 Pace American JT612TA2. Based on some images I could find it looks like your trailer uses the oval style light like the Optronics #STL72RB which is 6-7/16" long. If…

Sounds like you have the trailer hub part #8-247-50UC3-EZ installed on your trailer. That means for a grease seal you would need the part #RG06-050.

The battery you use for a break away system needs to be able to power the trailer brakes on full for 15 minutes. A 12 volt battery rated for 5 amp hours is normally used, unless you have 3 axles each with brakes, then you would benefit more from a 9…

In order to charge an on-board trailer battery you'd need to have a seven way connection on both the vehicle and trailer, this would contain the necessary circuits to pass a charge from the vehicle battery to the trailer battery. If you don't…

You can check the condition of your hub's races by carefully removing all bearing grease with a rag to expose the actual surface of the races. When they are completely free of grease, etc., inspect them for any signs of scoring (very slight…

To replace a spindle, the old one would need to be cut off, and the new one welded into place. This is NOT a job for the do-it-yourselfer. The new spindle must be absolutely square with the axle in order to prevent premature tire wear and wheel…

Trailer brake assembly #AKEBRK-7L-SA is a 12 x 2 inch assembly with a 5-bolt mounting pattern for 5.2K to 7K axles so it will fit in place of your existing 12 inch brakes! This is the left hand assembly. The matching right hand assembly is…

The biggest difference between Dexter brake assembly #23-459 and etrailer/AxleTek assembly #AKEBRK-7L-SA is the pad material. The Dexter assemblies use pads that are snapped off of a long strand of the material. The ones on the etrailer assemblies…

The most hidden trailer hitch available for your 2020 Dodge Durango is without a doubt the Draw-Tite Max-Frame Trailer Hitch Receiver #DT38MR. The 2" receiver for this Class III hitch will actually extend out through the bottom of the rear…

Even when stored in the somewhat controlled environment of a garage, tires are still subject to dry rot and flat spotting. Even if the tire tread has plenty of depth left and you can't see any cracking with the naked eye, the generally accepted…

The first thing to try to is add some penetrating oil like WD40 and let it sit for awhile. You can then try tapping the bearing to try and remove it. You don't want to hit it too hard because you can damage the spindle. It is possible that the…