Replacement Hitch Pin and Retainer Nut for Yakima Fourtimer

Question

Question:

I need a replacement anti-rattle hitch lock for my Yakima Fourtimer. Apparently I cross threaded the piece that attaches my rack to the hitch. Please tell me the part and part number via your website so that I ensure I purchase the correct part. Thanks so much,

asked by: Jc L

0

Expert Reply:

For the Yakima Fourtimer # Y02469 the part number for the replacement hitch bolt is # Y8890200 and the retainer/nut is part # Y90254.

expert reply by: Jameson C

0

Answer 1

I checked with Yakima and for their Fourtimer bike rack part #Y02469 the correct hitch bolt is the part #8890260 and then for the matching lock assembly you'd need the #8820048.

view full answer...

Answer 2

For the Yakima FourTimer, you'd use the #Y8890200 anti-rattle hitch bolt. I've confirmed this with Yakima.Y8890200

view full answer...

Answer 3

Hi Stephen; the retainer nut in the #Y90254 is designed to fit a 5/8"-11 bolt like yours. This also fits all generations of the Yakima HoldUp so it is the part you need.

view full answer...

Answer 4

We do have what you need but I checked with Yakima for you and the part you mentioned will not work with a Yakima FourTimer bike rack. Instead, there are a couple of parts you that you need, and I verified this with Yakima for you: - Replacement…

view full answer...

Answer 5

The Yakima Replacement Mounting Hardware part #Y8880129 is the replacement bolt you want for your Yakima Fourtimer part #Y02469.

view full answer...

Answer 6

It sounds like you are looking for a locking hitch pin lock for a Yakima hitch bike rack. If you can let me know what bike rack you have I can give you the exact hitch lock for your bike rack as recommended by Yakima. I can't recommend the use of…

view full answer...

Answer 7

Replacement Threaded hitch pin #Y8880129 is indeed longer than the original bolt. It is 4.28 inches long overall. Something that you should know though is that when using a hitch adapter like you mentioned it reduces the tongue weight capacity of the…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Replacement Hitch Pin and Retainer Nut for Yakima Fourtimer

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching