Furrion FOS07TASF Installation on Prewired Trailer Without Furrion Bracket

Updated 10/15/2020 | Published 10/14/2020

Products Featured in This Question

Replacement Antenna for Furrion Vision 1, 2, and S Wireless RV Camera Systems

(394)

$16.67

Replacement Furrion Monitor Power Cable

(368)

$41.63

Replacement 4.3" Monitor for Furrion Vision S Wireless RV Camera System

(98)

$243.50

Replacement Shark Fin Camera Mounting Bracket for Furrion Vision S RV Camera Systems - Black - Qty 1

(310)

$21.44

Replacement Suction Cup Mount for Furrion Vision S 4.3" Monitors

(269)

$25.70

Hook Probe Circuit Tester

(62)

$13.94

Question:

I purchased this backup camera for my 2019 Coachman Chaparrell 30RL. I though this was a plug and play install but when I removed the cover from the fin of the bracket there was not a plug, only a hard wire. Should there have been an installed plug? If so, which is the hot wire? Also the entire bracket is a diffent size than the existing bracket and I have to redrill all new holds. So much for plug and play system!

asked by: Mike G

Expert Reply:

The Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 4.3" Screen # FOS43TASF is the complete plug and play system for a prewired coach. It sounds like your 2019 Coachman Chaparrell 30RL is roughly prewired for a camera but there is nothing from the manufacturer that specifies the Furrion model. You will wan to add the Replacement Shark Fin Camera Mounting Bracket for Furrion Vision S RV Camera Systems - Black - Qty 1 # FRCBRKT-BL to get the correct mount as well as the wiring harness that you will connect to the existing wiring. You will need to use a circuit tester like # PTW2993 to determine which wire of the prewiring will connect to the red power wire and which will connect to the black negative/ground wire.

It also looks like the antenna is missing so you'll also want the Replacement Antenna for Furrion Vision 1, 2, and S Wireless RV Camera Systems # 772577. The plug you show in the photo is for the monitor which isn't pictured. If you need a monitor, I recommend the Replacement 4.3" Monitor for Furrion Vision S Wireless RV Camera System # FR77FR. This does not come with the mount or power cable, so if you need those you will use the Replacement Furrion Monitor Power Cable # C-FOS07TAPK-006 and mount # LC776462.