Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Replaces 1 shark fin style mounting bracket on your Furrion Vision S wireless RV backup and observation camera system (729125, 729936, or 732556). The pre-wired shark fin shaped bracket provides a waterproof housing for the camera.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello neighbors, it's Brad here at etrailer, and today we're taking a look at the Furrion Vision S Sharkfin Camera Mount. Now this is gonna be a great option for those of you that maybe have a damaged one of these that want to replace it. This is the factory one that comes with the camera, but this is just plastic. So if it cracks or if your gasket is starting to chip away, you wanna make sure that it's gonna keep it protected. This is a great option. Or if you are adding your own camera system, and want a nice mounting system that'll seal everything up, and put it at the right angle for the rear of your camper or your doorway, this is gonna be a great option.
Let's take a closer look. Now many new campers are gonna be prepped with a camera spot, and this bracket is the Sharkfin adapter and this bracket allows you to get a Furrion Vision S mounted up, no problem. And it also comes with the wiring. So this is really gonna be applicable to those of you that are wanting to either replace a broken mounting bracket, whether weather cracked, whatever, or your seal's just starting to go bad. You can fix that all by getting our replacement parts, and that way you don't have to buy a whole new system.
It really allows you to salvage, you know, the cost of the camera as well as the screen. And it's gonna be a great option for those of you that need a spot to mount up a camera. So if you have an aftermarket camera that you wanna mount up and you want it in the rear or on a doorway, a lot of times, getting that mounted up to where it's gonna be weather sealed, and not gonna get exposed to the elements can get a little bit tricky. And that's where this one really comes into play. Not only do you have this gasket with holes that allow you to pass the wire through, but you also can get this mounted up.
It's got a nice cover, so water and everything's gonna run off of it. In fact, today we have a bunch of rain and you don't have to worry about it getting on the lens of the camera as much. It's gonna protect it. And really simple, it's just got four screws and that's gonna open the cap. And that's where normally the Furrion Vision S would mount up and your antenna can go here.
But a lot of other camera manufacturers will work with this. So, it does not come with the screws to get it attached into the wall, but that's something that you can source. I do see that from the factory, they seal it up with a little bit of silicone, probably not a terrible idea, even though this gasket is gonna press and create that seal, you don't want water getting inside because getting electric run from the outside to the inside means that there is gonna be a hole for your electronics to be able to plug in. And speaking of that, included with it, I mentioned, was the wiring. This is gonna plug in directly to that Vision S, and then it runs to the positive and negative wires that you would attach inside to get that to work. So, pretty simple here, but really a great option. You know, if you had something fall and crack on this, no longer will, you have that watertight system for your camera, and that risk it, you know, not having a very long lifespan. So to replace that immediately, or to mount up your camera system on your camper on the rear or doorway, this is gonna be a great option for you. And that was a look at the Furrion Vision S Sharkfin Camera Mount Bracket for your RV.
Customer Satisfaction Score:
97% were satisfied with this product
3% of customers were not satisfied
Ratings & Reviews
Thetruthsayer
8/11/2022
It has performed as described. No issues, no leaks. It’s a great fit!
Gilles
8/25/2024
Everything perfet for now
Heather A.
3/25/2025
Hey mistakes happen Richard! How is this one working for you?
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
William
5/18/2026
Awesome! I just sold our camper and the camera stayed with me for our next trailer! It works great!