bing tracking image
Q & A Icon

Is Wire Harness on Back of Hot-Line LED Third Brake Trailer Light Bar Centered  

Updated 08/06/2020 | Published 08/05/2020

Question:

I intend to mount two of these inside a 3x 4lb/ft channel, which forms the rear crossmember on the small utility trailer I am building. How big is the hole through the channel I will need to drill to accommodate the pigtail? Is it positioned in the center of the light ficture? Thanks

0

Expert Reply:

If you check out the attached picture of the Hot-Line LED Third Brake Trailer Light Bar # 328-003-6017R that you referenced you can see that the wiring harness is right in the middle of the back of the light. A hole that is 3/4 inch in diameter would work well.

expert reply by:
0
Jameson C
click to enlarge

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>