Correct Lift Spacer for Ride Rite Kit F2299 with 6 Inch BDS Lift

Question

Question:

Im looking for a lift spacer for part #6401. Im installing a BDS 6inch lift kit on to my 2008 Dodge Ram 2500 6.7L currently the difference from front to back is 3 inches. I assume Id need a 3in spacer to level out the back with front, once the kit is installed.

asked by: Joshua

0

Expert Reply:

The correct size lift spacer you will need for your Firestone Ride Rite airbags depends on how much the BDS Lift Kit will lift the rear of the vehicle.

If the kit lifts the rear of your truck by 3 inches, then you would want a 3 inch spacer, # F2367.

I'm not sure if I found the same kit you are purchasing or not, but in my research I found some BDS 6 inch kits that use a 4 inch lift for the rear. If the kit lifts the rear of the truck by 4 inches, then you would want a 4 inch spacer, # F2370.

expert reply by: Victoria B

0

click to enlarge

Answer 1

The 2 inch receiver for the EcoHitch Hidden Front Mount Trailer Hitch #306-X7900 referenced in your question will actually protrude through the grille of your truck. This allows for a really clean appearance while also maintaining your existing…

view full answer...

Answer 2

Hey Tiffany! The Timbren SES - Severe Service #T94VR is designed for a constant load like your truck bed camper. However, since you're worried about unloaded ride quality I would stay away from Timbren as a solution. Even if you get the standard…

view full answer...

Answer 3

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 4

Hello Matt, thanks for reaching out. We do have an air bag kit that will fit your 2007 Ram 2500 SLT 4x4 long bed with the Reese 5th wheel kit in the bed. For that I recommend the Firestone Ride-Rite Air Helper Springs #F2299. The brackets in this kit…

view full answer...

Answer 5

For your 2010 Dodge Ram 3500 you're going to have a couple of options to choose from. - If you have a crew-cab 4x4 with a single rear wheel and a 6-1/2' bed then you're going to need the TorkLift Custom Frame-Mounted Camper Tie-Downs…

view full answer...

Answer 6

There are a number of differences between the Firestone Ride-Rite Air Helper Springs #F2445 and Air Lift LoadLifter 5000 Ultimate Air Helper Springs #AL88299, starting with fit. While the Air Lift will fit all models of the 2018 Toyota Tundra, the…

view full answer...

Answer 7

Yes the Firestone Ride-Rite Air Helper Springs #F2299 is going to work with the Firestone Air Command I - Analog Gauge w/ Standard-Duty Compressor #F2158. The Air Command can work with your tires but I do recommend going with the Firestone Air Tank,…

view full answer...

Answer 8

Hey Jeff. We've got the Red Label Firestone Ride-Rite Extreme Duty Air Helper Springs item #F2709. These have a 7,500 lbs capacity and are confirmed to fit your 2018 Chevrolet Silverado 2500. I recommend adding the Firestone Air Command item…

view full answer...

Answer 9

I would be happy to help you but there are so many different lift options its going to require you to take some measurements of your Chevy Silverado 2500's suspension. Most lift kits don't lift the same amount in the front as they do the…

view full answer...

Answer 10

Good question. Let's clear it up. On the Firestone Ride-Rite Air Helper Springs part #F2558 they are as follows. 1. The 5/8inch Nylon jam used to connect the upper bracket to the air spring? 15-20 ft/lb. 2. The 3/8inch hex bolt used to connect…

view full answer...

Correct Lift Spacer for Ride Rite Kit F2299 with 6 Inch BDS Lift

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching