Brake Controller Installation on 2004 Ford F250

Question

Question:

Code: C74VV-C51322 So I am looking at this product for my 04 f250 6.0 Powerstroke 4x4 I’m just not sure if my truck is factory 7way or factory 4way I have both. Just got truck used and not sure if someone installed after thank you

asked by: Ricky

0

Expert Reply:

Your 2004 Ford F250 will have the brake controller connector located under the dash right above where the driver's right knee would be as shown in the video I've linked for you. Simply use the # C51322 harness to plug the Curt # C74VV Venturer brake controller into the gray connector as shown.

It doesn't really matter if your truck's 7-way is OEM or not, as long as it's functional. If you have any difficulties, please let us know and we'd be happy to assist.

expert reply by: Mike L

0

Answer 1

Time-delay type brake controllers can offer advantages in specific applications but in general most people prefer the more predictable performance from a proportional unit that slows the trailer in direct relation to the rate of deceleration in the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 8

We can get you everything you need for towing with your 2017 Toyota Sienna XLE. By plastic shield, I believe you are referring to the appearance panel underneath the Sienna, and that will have to trimmed a bit in each of the hitches available for the…

view full answer...

Brake Controller Installation on 2004 Ford F250

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching