How to Manually Operate the Ultra-Fab Deluxe Electric Landing Gear Set
Published 01/24/2020
Question:
What happens when a motor fails. How would you raise up rv. Or batteries fail. Is there a way of raising rv up. I just purchased this item and it just occurred to me.
asked by: Ruben L
Expert Reply:
Good question; if for some reason there is an issue with the power or motor, you can manually operate the Ultra-Fab Deluxe Electric Landing Gear Set # UF17-943010.
I took a look at the instructions, and the accompanying cut out from them explains what you'll need to do. There are four screws that hold the motor and gear assembly on, and you'll need to remove those and turn the slotted shaft with a flathead screwdriver.
Product Page this Question was Asked From
Ultra-Fab Deluxe Electric Landing Gear Set - Weld On - 38" Lift - 12,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Steel
- 10001 lbs or More
- Electric Jack
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: trailer leaf springs
- Search Results: bronze bushings
- Search Results: landing gear
- Search Results: rv steps
- Shop: Dexter Double-Eye Leaf Spring - 26" Long - 1,875 lb Capacity
- Shop: Ultra-Fab Deluxe Electric Landing Gear Set - Weld On - 38" Lift - 12,000 lbs
- Shop: 5-Leaf Double-Eye Spring for 6,000-lb Trailer Axles - 25-3/8" Long
- Shop: Wet Equalizer Bolt with Locknut and Grease Zerk for Double-Eye Springs - 3" Long
- Shop: U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles - 7" Long U-Bolts
- Shop: Dexter Bronze Bushings - Qty 4
- Shop: Step Wet Bolt for 1-3/4" Double Eye Springs
- Video: Detailed Breakdown of the Step Wet Bolt for 1-3/4" Double Eye Springs
- Video: Installing the Dexter U-Bolt Kit on a 2018 Grand Design Reflection Fifth Wheel
- Video: Detailed Breakdown of the U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles
- Video: Checking Out the Ultra-Fab Deluxe Electric Landing Gear Set
- Q&A: How to Choose the Correct Replacement Landing Gear for 5th Wheel Trailer
- Q&A: Replacement Landing Gear for Frame Clamps That Measure 18-1/2 Inches Apart
- Q&A: Could Ultra Fab Dual Motor Landing Gear Replace Lippert Landing Gear
- Search Results: ultra~fab
- Video: Ultra-Fab Products Trailer Jack UF17-750007-003 Review
- Q&A: Recommended Trailer Landing Gear with Independent Motors for 2009 Heartland Cyclone 3950
- Q&A: Are Ultra Fab Landing Gear Jacks a Solid Replacement for Jayco RLDS
- Q&A: Best Landing Gear Upgrade Options for 5th Wheel Trailer
- Video: Ultra-Fab Spring-Loaded Quick Pins for Landing Gear Drop Legs Spec Review
- Q&A: Atwood 87701 landing gear switch replacement
- Video: TRED GT Wheel Chocks Review