How to Manually Reset Lippert Ground Control System
Updated 03/10/2025 | Published 01/06/2020
Products Featured in This Question
Question:
How to reset it I get a error code right rear jack sometimes it says front left jack can manually run everything down
asked by: Jay
0
Expert Reply:
To manually reset your Lippert Ground Control part # LC358590 you need to hold down the retract and enter buttons at the same time. Try that but if you still get an error code you most likely have a low voltage battery that needs to be charged. Or if that's not it the wiring of the system needs to be checked out.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Lead Leg for Lippert Components Ground Control 3.0 Electric Leveling System - Qty 1
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Lippert
more information >
Continue Researching
- Search Results: lippert ground control 30
- Shop: Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System
- Q&A: Troubleshooting Comm Error Check Wiring Code On Lippert Ground Control 3.0
- Shop: Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System
- Video: Lippert Ground Control 3.0 Electric Leveling System Replacement Control Module Review
- Shop: Replacement Control Touch Pad for Power Gear RV Auto Leveling System
- Q&A: Troubleshooting Comm Error on Lippert 3.0 5th Wheel Leveling System
- Q&A: Troubleshooting Comm Error Check Wiring Code On Lippert Ground Control 3.0
- Shop: Rubber Hole Cover for Reese Elite Series Under-Bed Gooseneck Trailer Hitch
- Shop: 5-Leaf Double-Eye Spring for 6,000-lb Trailer Axles - 25-1/4" Long
- Shop: Thinline LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 15 Diodes - Red Lens
- Shop: Replacement CAN Bus Data Cable for Lippert Ground Control or OneControl Leveling System - 20 Ft
- Search Results: lippert leveling system replacement parts
- Q&A: How To Test for Bad Controller on Lippert Ground Control 3.0 Electric Leveling System
- Q&A: What to Replace When I Get the Comm Error on a Lippert Ground Control 3.0 6-Point Leveling System
- Q&A: Wiring Diagram and Fuse Location for the Lippert Ground Control 3.0 4-Point Leveling System
- Q&A: Wiring Diagram for Lippert Stabilization Jack LC298707
Kd
3/8/2025
What if I’m plugged into shore power and still getting error code?