How to Clear Error Code on Lippert Ground Control Leveling System
Updated 08/04/2022 | Published 07/31/2017 >
Question:
I have an error code that says L F jack. it says to retract all jacks and hit enter to clear. i have tried that and a bunch of other things and still cannot get the error code to clear. sometimes the location of jack changes on display but always results in the same way. only had the camper for 2 weeks. it is a 2016 326rds cougar fifth wheel. any suggestions?
asked by: T.J. K
Expert Reply:
We have heard of this issue before on the Lippert Ground Control systems # LC358590.
Here is the recommended procedure for clearing the error code: Extend all jacks at least 6 inches. Then press and hold the RETRACT button until the jacks begin retracting. All of the jacks should fully retract and clear the error.
If that does not clear the error code disconnect all connectors to let the system power down completely for about 15 minutes. The re-connect and follow the procedure again if the error code reappears.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: kwikee rv steps
- Search Results: rv steps
- Shop: Fifth Wheel Hitch
- Shop: Tonneau Cover
- Search Results: screen door latch
- Search Results: lippert screen assist
- Search Results: sumosprings rear
- Shop: RVpaws V2 Premium Articulating RV Jack Pads for 2" Round Jack Legs - 9" - Qty
- Shop: Brake Controller
- Shop: Replacement Front Jack for Lippert Ground Control 3.0 Leveling System
- Search Results: rv leveling blocks
- Shop: Redarc Tow-Pro Link Bluetooth Brake Controller - Off-Road Mode - 4 Axles - Proportional
- Search Results: rv levels
- Shop: BAKFlip G2 Hard Tonneau Cover - Folding - Aluminum
- Shop: BAKFlip MX4 Hard Tonneau Cover - Folding - Aluminum - Matte Finish
- Shop: Bestop EZ Fold Folding Tonneau Cover
- Shop: Kenda Loadstar 205/65-10 Bias Trailer Tire w/ 10" Solid Center Wheel - 5 on 5-1/2 - LR E
- Shop: Suspension Enhancement
- Shop: Vehicle Tow Bar Brake System
- Video: Replacement Front Jack for Lippert Ground Control 3.0 Leveling System Review
- Q&A: How To Test for Bad Controller on Lippert Ground Control 3.0 Electric Leveling System
- Q&A: Lippert Ground Control Leveling System Shows ERROR, LF Jack
- Video: Checking Out the Lippert Magnetic Cross Check Bubble Level
- Video: All About the Lippert Round Bubble Level for RVs
- Shop: Base Plate for Tow Bar
- Shop: Vehicle Tow Bar Wiring
- Video: Review of MORryde Replacement Stability Disc Kit Rubber Pin Box - MR26RV
- Video: Replacement Rubber Compression Bumper for MORryde Pin Boxes Feature Review
- Video: Install: Blue Ox Patriot Portable Flat Tow Brake System on a 2022 Jeep Wrangler Unlimited
- Q&A: Replacement Front Jack For Lippert Ground Control 3.0 6-Point System


Joe
6/21/2020
I’m having the same issue with my Lippert gen 3 system. Battery died during leveling. Now the error won’t go away no matter what I do. Holding auto retract seems to cause an issue too. I swear my leveling system was made by the government. I have more problems with this leveling error than anything else.