Curt Triflex Brake Controller Displaying d.C. Error Code when Trailer Connected
Published 10/17/2019 >
Products Featured in This Question
Question:
When I apply the brakes they stay applied for about 30 seconds then release. When applied controller showed code d. c. Then brakes are released it shows code DD. Tv is 2016 Ford Escape trailer is Flagstaff t12ddst. Thanks.
asked by: Brad
Expert Reply:
When the display flashes a d.C. code, it means no trailer is connected (or at least that's what it's detecting). This could be either because the trailer connection has become unplugged, there is a bad pin, a bad wire or the trailer brake magnets are malfunctioning.
To start, check trailer connector and make sure both the trailer and vehicle ends are free of corrosion or rust and no pins are loose or missing. Also check for any crimped, frayed or pinched wires and repair as needed. I recommend testing the brake output wire (blue) with a tester like # PTW2979 to ensure proper voltage is passing through and not interrupted somewhere along the length of the wire.
I'm not sure what DD error code means as it's not listed on the troubleshooting chart in the user manual. However, it wouldn't hurt to reset the the unit by simply unplugging and re-connecting it after about 15-20 seconds so it can re-calibrate.
Refer to method # 4 on the FAQ I've attached at the bottom of the page to troubleshoot your brake magnets.
If your connectors, wiring and magnets are in good working order and re-setting the Triflex does not correct your issue, it likely means there is an internal issue and the only solution is to replace the controller.
Fortunately, the # C24VV is backed by a limited lifetime warranty. I wasn't able to find a record for your order so I recommend reaching out to the original seller for more details on the warranty process.
Product Page this Question was Asked From
Curt TriFlex NEXT Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Plug-In
- Under-Dash Box
- Under-Dash
- Up to 4 Axles
- LCD Display
- Single Trailer Only
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: andersen trailer hitch ball mount
- Search Results: trailer tires and wheels
- Search Results: trailer lights
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Kenda Karrier KR53 ST205/75R14 Radial Trailer Tire with 14" Black Mod Wheel - 5 on 4-1/2
- Shop: Rapid Hitch Adjustable, Aluminum Ball Mount Kit w/ 2 Zinc Balls - 5-1/2" Drop
- Search Results: swivel d ring
- Search Results: break away battery
- Search Results: tube cover
- Search Results: rv step covers
- Shop: Dexter Trailer Springs Over-Under Conversion Kit
- Shop: Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 7-Way and 4-Pole Flat Connectors
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: MaxxTow Ball Mount w/ 2" Accessory Receiver - 2" Hitches - 2-1/4" Drop - 5,000 lbs
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Q&A: Troubleshooting D.C and C.C. Messages on Curt Triflex Trailer Brake Controller
- Q&A: No Power to Trailer Brakes with Brake Pedal on a 2006 Chevy Silverado 2500HD
- Q&A: Troubleshooting r.C. Error Code on Display of Curt Triflex Brake Controller
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Suspension Enhancement
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Shop: Brake Controller


