Can LaSalle Bristol XTRM Acrylic Adhesive be Laid over Eternabond

Question

Question:

Is this product ok to lay over seam tape such as Eternabond?

asked by: Jeramie

1

Helpful Expert Reply:

Yes, the LaSalle Bristol XTRM Adhesive # 344270341415 can be laid over Eternabond.

expert reply by: Jameson C

1

Answer 1

You could remove the roof to fix the staples but that would require a ton of work and can be costly, which is why Alpha said it would be overkill. You could just hammer the staples back down and just use some self leveling sealant like the Alpha…

view full answer...

Answer 2

The LaSalle Bristol XTRM EXP 90 Adhesive for RV Roofs #344270341415 must be applied to a clean and porous surface. So you will not be able to apply the adhesive to itself. You must either sand the surface clean or apply the new roof sheathing.

view full answer...

Answer 3

Most slides have EPDM rubber roofs but because EPDM is rubber it requires treatment each year to keep it soft and prevent shrinkage. You could replace it with TPO which is another synthetic rubber that will last longer than the EPDM. The smallest…

view full answer...

Answer 4

I checked with my roof installer, and got a hold of a sample of the LaSalle Bristol #3441700534142711435 myself, and found out that either side can be glued down. There is no up or down. Both sides are identical. This membrane is glued down with…

view full answer...

Answer 5

LaSalle Bristol XTRM PVC RV Roof Membrane #3441700534142711435 has been tested on temperatures as cold as negative 40 degrees F so you would be fine. That's really cold!

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Can LaSalle Bristol XTRM Acrylic Adhesive be Laid over Eternabond

Product Page this Question was Asked From

Continue Researching