What is Minimum Temperature for LaSalle Bristol XTRM PVC Roof Membrane Can Handle

Question

Question:

Can that PVC support extreme cold temperature, minus 35 F. Canadian winters !!! Thanks

asked by: Michel C

0

Expert Reply:

LaSalle Bristol XTRM PVC RV Roof Membrane # 3441700534142711435 has been tested on temperatures as cold as negative 40 degrees F so you would be fine. That's really cold!

expert reply by: Jameson C

0

Answer 1

Hey David, The LaSalle Bristol RV Roof Replacement Kit w/ XTRM Membrane #344270KIT30 does need to be installed on a clean surface per the installation instructions: - Make sure the deck is clear of all debris. NOTE: XTRM PLY membrane must be…

view full answer...

Answer 2

The LaSalle Bristol XTRM EXP 90 Adhesive for RV Roofs #344270341415 must be applied to a clean and porous surface. So you will not be able to apply the adhesive to itself. You must either sand the surface clean or apply the new roof sheathing.

view full answer...

Answer 3

Most slides have EPDM rubber roofs but because EPDM is rubber it requires treatment each year to keep it soft and prevent shrinkage. You could replace it with TPO which is another synthetic rubber that will last longer than the EPDM. The smallest…

view full answer...

Answer 4

The lowest temperature that the LaSalle Bristol XTRM EXP 90 Adhesive for RV Roofs - White - 2 Gallon #344270341415 can be applied at is 50 degrees Fahrenheit.

view full answer...

Answer 5

Yes, the LaSalle Bristol XTRM Adhesive #344270341415 can be laid over Eternabond.

view full answer...

Answer 6

I discussed with Shane your questions of laying down the LaSalle Bristol RV Roof Replacement Kit w/ XTRM Membrane, #344270KIT40. He stated to use a squeegee of the type used on bathroom walls or glass shower doors, it will need to be stiff. As for…

view full answer...

Answer 7

You would want to measure the distance of the opening of the vent. The Vent Cover #BV0554-03 that you referenced fits 14-1/4 by 14-1/4 inch openings. Nearly all roof vents are 14-1/4 inch by 14-1/4 inch. You probably have one of the styles that we…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

What is Minimum Temperature for LaSalle Bristol XTRM PVC Roof Membrane Can Handle

Product Page this Question was Asked From

Continue Researching