What are the Measurements of the Derale Snap-In Radiator Adapter Fitting, # D13035

Question

Question:

what are the measurements on 13035 Derale GM radiator adapter

asked by: Larry P

0

Expert Reply:

I went out to the warehouse and pulled a Derale Snap-In Radiator Adapter Fitting, # D13035, to take some measurements for you.

The overall length is 2 inches. The larger flare is approximately 0.48 inches in diameter and the smaller flange is 0.43 inches in diameter. The diameter of the main body is 0.37 inches. And finally the diameter of the opening on either end is 0.27 inches.

I produced a picture that shows the dimensions for you.

expert reply by: Michael H

0

click to enlarge

Dwayne

7/29/2020

does this adapter work for Dodge caravan or Town & country.?

Jon G.

8/5/2020

Either of those vehicles should be compatible with a cooler like the Derale Series 8000 # D13503 which comes with the Insta-dapt radiator adapter. This can be found individually as part # D13004.

Answer 1

The transmission cooler part #D13504 would be exactly what you need. This is a large cooler that would work well for your 2007 GMC Yukon Denali. I attached an install video that shows it being installed in a very similar 2009 Yukon as yours. Your…

view full answer...

Answer 2

The blue brake wire should not always be hot; what that means is you likely have a short somewhere that you will need to find. To do this and look for wires that may be pinched or otherwise damaged and fix as necessary or replace it with 10 gauge…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

What are the Measurements of the Derale Snap-In Radiator Adapter Fitting, # D13035

Product Page this Question was Asked From

Continue Researching