How To Hook Up the Identification Light Bar MCL97RB To a Two Wire Plug
Updated 06/26/2019 | Published 06/24/2019
Products Featured in This Question
Question:
How do you connect to a two wire plug set on a shorelandr trailer?
asked by: Shane R
Expert Reply:
I am not familiar with the two wire plug set on your ShoreLand'r Boat Trailer but the Identification Light Bar part # MCL97RB only has one wire which will need to be connected to the running light circuit (usually brown wire) on your trailer with a quick splice connector part # SWC501746-1. The ground for the light is integrated into the base which is why there is not a separate wire for this. If the two wire plug you are referencing has a wire for the running light circuit and one for the ground or something else then you would just leave this wire unattached.
Product Page this Question was Asked From
Identification Light Bar for Trailers over 80" Wide - Submersible - 9 LEDs - Silver Base - Red
- Trailer Lights
- Clearance Lights
- Marker
- Light Bar
- Surface Mount
- Submersible Lights
- LED Light
- 14L x 1W Inch
- Red
- Optronics
more information >
Continue Researching
- Shop: Trailer Wiring
- Shop: Identification Light Bar for Trailers over 80" Wide - Submersible - 9 LEDs - Silver Base - Red
- Search Results: trailer lights
- Search Results: butt connectors wiring
- Shop: Optronics LED Combination Trailer Tail Lights - Submersible - 40 Diodes - Driver and Passenger Side
- Shop: Identification Light Bar for Trailers over 80" Wide - Submersible - 9 LEDs - Silver Base - Red
- Search Results: heat shrink butt connector
- Search Results: accessories and parts
- Q&A: Difference Between the MCL97RB and MCL97RPG Optronics Identification Light Bars
- Shop: Identification Light Bar for Trailers over 80" Wide - Submersible - Silver Base - Red
- Q&A: Replacement Passenger Side Tail Light for Sun Tracker Trailer
- Video: Ultimate Overview of the Optronics LED Trailer Clearance or Side Marker Light
- Search Results: marker lights
- Shop: Optronics LED Clearance or Side Marker Light - Submersible - 3 Diodes - Rectangle - Amber Lens
- Q&A: Single Wire ID Light Bar for a Boat Trailer Over 80 Inches Wide
- Video: Complete Breakdown of the Identification Light Bar for Trailers over 80" Wide
- Video: LED Identification Light Bar for Trailers over 80" Wide: The Breakdown
- Q&A: Identification Light Bar for Trailers over 80" Wide that Grounds Through the Mounting Hardware
- Shop: LED Identification Light Bar for Trailers over 80" Wide - Submersible - 9 Diodes - Red Lens
- Search Results: trailer wiring
- Search Results: trailer brakes
- Shop: TecNiq T14 Over 80" ID Bar and Load Lamp - Red/White Combo - Surface Mount
- Q&A: installing New Light Bar With Only One Wire On Boat Trailer
- Q&A: What is Blue Piece For Optronics Identification Light Bar
- Video: LED Identification Light Bar for Trailers over 80" Wide Review
- Video: All You Need to Know About the Optronics LED Clearance or Side Marker Light
- Q&A: Do I Need to Remove the Identification Light Bar to Replace the Lights?
- Video: Review of the Optronics LED Combination Trailer Tail Lights
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
on Trailer Lights
