Recommended Rebuild Gear Kit for Bulldog Jack
Updated 04/03/2019 | Published 04/02/2019
Question:
I have a cattle trailer with a bulldog square jack on it. recently, it is getting increasingly harder to lower or raise the jack. I took the square plate off jack, but mine is a 1983 trailer, so there is a drive in pin, instead of a spring on shaft.. The pin seems to be stuck in the turning rod. How to get the pin out, without damaging the jack.
asked by: Horace M
Expert Reply:
Without the spring that holds the shaft pin and gear in place, you likely will need to drive that pin out as it is likely pressed in. If it is really stuck in there, you may need to drill it out to ensure you don't damage the jack. Then you can use the Replacement Gear Kit for Bulldog Sidewind Jacks w/ 12,000-lb Capacity # BD500212.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Replacement Rod and Nut for etrailer and Ram Square, Direct Weld Jacks - 12K
- Shop: Replacement Inner Tube with Drop Leg, Foot, and Pull Pin for Curt Heavy Duty Direct Weld Square Jack
- Shop: Square Direct Weld Trailer Jack w/ Footplate - Drop Leg - Topwind - 15-1/4" Lift - 7,000 lbs
- Video: Review of etrailer Replacement Return Spring etrailer Ram Square Direct Weld Jack - TJD-12000-RSP
- Q&A: Replacement Drop Leg 12K Jacks for a 2016 14k PJ Trailer
- Shop: Bright Way Trailer Breakaway Kit with Charger, LED Tester, and 5 Ah Battery - Side Load
- Q&A: What is the Purpose of the Spring Inside of a Bulldog 12K Square Jack
- Q&A: Are the Spring Returns of Bulldog Jacks Repairable if the Spring Return Function Stops Working
- Shop: Replacement Miter Gear Kit for Dutton-Lainson Trailer Jacks - 1,250 - 2,000 lbs. (1996 and Newer)
- Shop: Replacement Return Spring for etrailer and Ram Square, Direct Weld Jacks - 10,000 lbs
- Video: Rebuilding Your Trailer Jack
- Q&A: Bevel Gear Replacement For Happijac Truck Camper Jack System # LC736514 # LC736515
- Q&A: How to Access the Gears for the Heavy-Duty 12000 lb Bulldog Jacks
- Q&A: Troubleshooting A Roll Pin That Won't Slip Into Place In A Bulldog 10K Square Jack
- Q&A: Replacement Nut and Screw for an Older Bulldog 180 Series Jack
- Search Results: trailer hitch
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: trailer tires and wheels
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Shop: Suspension Enhancement
- Article: How to Measure for Trailer Hitch Drop
- Search Results: trailer wiring
- Shop: Brake Controller
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Search Results: trailer jack
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Search Results: trailer lights
on Accessories and Parts
