Correct Replacement Motor for a Bulldog 12K Jack
Updated 08/14/2023 | Published 08/12/2023
Question:
My HD jack will not go down even w/full charged batteries it also will not hand crank down.
asked by: Bel C
Expert Reply:
It sounds like either the motor is shot or the gears are worn. You're going to want to test the voltage of the motor first before deciding to replace it. If your motor is not getting enough voltage then you're just going to need to replace it with the Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity # BD1824200100.
This kit is going to include the powered-drive assembly, the torque stop tube with energy absorber, a terminal box, a wiring harness and switch box, a hex coupling, and a weatherproof cover, and will work with Bulldog 12K jacks.
If it turns out that your motor is good, then your gears are are going to need to get replaced with the Replacement Gear Kit for Bulldog Sidewind Jacks w/ 12,000-lb Capacity # BD500212.
(click to enlarge)
Continue Researching
- Video: Rebuilding Your Trailer Jack
- Q&A: Bevel Gear Replacement For Happijac Truck Camper Jack System # LC736514 # LC736515
- Q&A: How to Access the Gears for the Heavy-Duty 12000 lb Bulldog Jacks
- Q&A: Replacement Screw And Gear Kit Needed For 12K Bulldog 180 Series Jack
- Q&A: Troubleshooting A Roll Pin That Won't Slip Into Place In A Bulldog 10K Square Jack
- Q&A: How to Remove Pin in Handle Shaft to Replace Gears on an Older Bulldog Model 12 Square Jack
- Q&A: Which Replacement Screw And Gear Kit For Older Bulldog 180 Series Jack?
- Q&A: Replacement Nut and Screw for an Older Bulldog 180 Series Jack
- Shop: Trailer Hitch
- Search Results: trailer tires and wheels
- Shop: Trailer Wiring
- Search Results: trailer jack