Where To Install Kats Block Heater KH11812 on a 2012 Hyundai Genesis with the 3.8L V6 Engine

Updated 02/27/2019 | Published 02/25/2019

Products Featured in This Question

Kat's Heaters Custom Fit Engine Block Heater - Cartridge Style - 120V - 400 Watts

(185)

$96.71

Kat's Heaters Plug Cover for Power Cords with 3-Prong Plugs

(25)

$8.90

Question:

I was previously given the rear right as a location to install kats 11812 cartridge heater. But the instructions say left front in the heater package. Which one would be correct? Vehicle is 2012 genesis sedan 3.8 v6

asked by: John

Expert Reply:

According to Kat's Heaters, the Kat's Heaters Custom Fit Engine Block Heater part # KH11812 which is a fit for your 2012 Hyundai Genesis with the 3.8L V6 engine will install in the right hand side on the rear of the engine which is labeled as "RR" in the attached diagram. I have also attached the specified location directly from the application guide for Kat's Heaters.

I am not sure which set of installation instructions you are referring to but the above is the correct location. Once you find the hole in the block for the heater you can then follow the attached instructions:

1) Clean cartridge hole of all debris. Use compressed air.
2) Attach cord to heater.
3) Install heater into the hole. Rotate the clip on the cord to the proper position to secure the heater and cord to the engine block and heater.
4) Route the cord through the grill, using cable ties to prevent the cord from getting in contact with any hot or moving parts.

Don't forget to use the Kat's Heaters Plug Cover part # KH28405 so you can protect the plug from corrosion and shorts while not in use.