Comparing the Dutton-Lainson Swivel Pin to the Fulton Swivel Pin
Updated 09/15/2017 | Published 09/14/2017
Question:
What is the difference between DL22454 and F0933307S00? Also, what is the distance from the cotter pin hole to the end? Thanks for you help
asked by: Jerry H
0
Expert Reply:
I pulled both products from the warehouse to measure and compare for you. The Dutton-Lainson pin # DL22454 (unlike the page photo) has the cotter pin hole in line with the handle and is 1-7/16 inches from the end to the cotter pin hole center. The Fulton pin # F0933307S00 has the hole on the side of the unit and is 1-7/8 inches for the end to the center of the cotter pin. Both pins have a 1/2 inch diameter.
expert reply by:
Jason S
0
click to enlarge
Product Page this Question was Asked From
Replacement Swivel Pin Kit for Trailer Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pins and Clips
- Dutton-Lainson
more information >
Continue Researching
- Q&A: Available 1/2-Inch Diameter Plunger Pin for Trailer Jack
- Q&A: Replacement Swivel Handle Kit Part DL22449 Measurements
- Shop: Replacement Plunger Pin Assembly for etrailer and Ram Jacks - 1/2" Diameter
- Shop: Replacement Swivel Pin Kit for Trailer Jacks
- Shop: Replacement Swivel Handle Kit for Dutton-Lainson Jack
- Q&A: Recommended Rear Stabilizer Jacks for a 14,000 lbs Trailer
- Q&A: Can a DC to DC Charger Be Mounted in a Trailer's Battery Box to Keep the Trailer Battery Charged?
- Q&A: Which Electric Over Hydraulic Actuator is Best for Trailer Brakes
- Q&A: Identify Older Hayes Brake Magnet
- Q&A: How Long Does It Take to Install B&W Turnoverball Underbed Gooseneck Trailer Hitch BWGNRK1020
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Wiring Diagrams