Compatibility of the BAKFlip G2 Hard Tonneau Cover # BAK26331 and Tool Box on a 2017 Ford F-350

Updated 07/28/2017 | Published 07/27/2017

Question:

I have a chest type tool box 56in. x 15 3/4in. x 20in. x 18in located against front of the bed. will this still be accessible with this cover. or would I have to remove it to get into tool box. I also use gooseneck trailer connection quite a bit so I think from the video I can just fold up to the last section and should be ok. correct?

asked by: James M

Expert Reply:

It really depends on how much room your tool box takes up in the bed of your 2017 Ford F-350. If it sits near the front (cab-side) of your bed and is about as tall as the sides of your bed then you will need to move it forward because there is a little bit of a hinge rail where the BAKFlip G2 Hard Tonneau Cover # BAK26331 secures to the bed. This piece is about 6-1/2 inches wide.

You will also need to check the side-to-side clearance. If your tool box pretty much touches the sides of the bed already then you might have problems because the rails that the BAKFlip G2 installs on sit 1-1/2 inches inside of the bed side rails.

You will be able to fold up that last section while pulling a gooseneck trailer, yes.

expert reply by: Jon G