To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
It’s frustrating to remove your cover every time you need to haul something tall. With the BAKFlip G2, you just fold it up. The quad-fold design opens in sections so you can access part or all of the bed in seconds. Prop rods secure the cover upright when you need full clearance for larger loads, and built-in buckles let you fasten it partway open for smaller cargo. You can even drive with it folded up against the cab without blocking your rear window.
Weather and wear are no match for this setup. The G2 uses ½-inch-thick rustproof aluminum panels with insulated cores for strength and rigidity. Matte black rubber perimeter seals help keep water out, while the built-in drainage channels route away any seepage through hoses behind the cab. The textured black paint resists UV rays and corrosion, so it keeps looking sharp even after years in the sun and rain.
Security shouldn’t take extra effort. Each panel on the G2 automatically latches into place as you close it, locking tight when your tailgate is shut. You only need to drop the tailgate and pull one of the easy-reach release cords to open a section. With the solid aluminum construction and tamper-resistant design, your gear stays protected from prying hands and bad weather alike.
Some covers spoil the lines of your truck, but this one sits flush inside the bed rails for a sleek, low-profile look. Because it mounts inside, you still have access to stake pockets and side-rail accessories like racks or tie-downs. Installation is straightforward—no drilling required—just clamp the aircraft-grade aluminum rails in place and bolt on the hinge rail at the front using a wrench. Once tightened, everything aligns cleanly for a snug fit.
The G2 isn’t just for looks—it’s tough enough for real use. When closed, it supports up to 300 pounds of evenly distributed weight, so climbing or setting gear on top is no problem. Between its heavy-duty aluminum construction, powder-coated frame rails, and smooth nylon-housed latches, this cover is made to handle years of hauling, loading, and everyday driving without losing its fit or function.
Ratings & Reviews
great cover for my 5th wheel hitch and any loose items I carry. Just flip 3 times to tow my 5ver and go.
This is the third Bak flip G2 Yard Tonneau Cover. Like that they are strong enough to hold test shap and fold flay enough the I can use the bed camera on my F-350 to help me hook up to the 5th wheel. And when it is closed and my tailgate is locked does provide some protection against theft of anything in the bed. I would recommend the cover to anyone that needs one.
Overall, a good product. This is the third BakFlip I've owned on different trucks. Quality wasn't as good as older units. The wires to release the latches are too long and get trapped inside the cover so you can't reach them. I added pieces of tape to fix this problem. Also, the nylon straps to hold it open are a nice addition but the plastic buckles broke almost immediately. Older units with metal rings for you to attach bungee cords was a better design.
As always, etrailer service & delivery are outstanding!
We purchased the BAK Industries BAKFlip G2 Tonneau Cover for our 2019 Ram 2500. We use this cover for security/keeping the weather off of our camping accessories for our RV. The cover works great and is fairly waterproof. The only issues we have had is the 1st latching cable, most of the time we need to pull the cable release from both sides to release the locking lugs to open. Over-all a good purchase, and would recommend it for anyone looking for a hard cover.
Great Tonneau Cover for my Ford Maverick, no issues in a year so I don't suppose there will be any. Fit is perfect and adds class to my little truck. Thanks for a good product.
This is the second BAKFlip G2 Hard Tonneau Cover we have purchased. The first was for our 2005 Chevy. This is for our 2017 GMC. The 2005 fit much better. The 2017 model is not wide enough to actually fit the bed allowing water to easily enter the bed. Also the posts that hold the cover up against the cab were drilled wrong. You have to remove the slide to fit the prop rod. They simply drilled the hole for the nutzert in the wrong spot on the passenger side. Just not the same quality fit or finish as the 2005 version. We would have returned it but sending it back was going to be too much of a hassle due to its size.
This cover is now completely junk due to a hail storm. No fault of BAKflip but the hail storm destroyed the cover is seconds. The aluminum used in this model is just too light to protect from any type of impact.
I was impressed with how your company staff received my order request, how company staff kept me updated on order status and delivery. Installation went very well. The instruction manual was well detailed. I am very satisfied with your cover. The cover fits perfectly. I continue to receive compliments. Thank you from a very satisfied customer.
Great cover!! It was easy to install and has kept everything stored under it clean and dry. I would definitely recommend it.
The tonneau cover is excellent when you get it installed properly. I can only give it a 3 rating because the workmanship of their latches the way they installed them was very shabby. Had to move all the latches back into their frame so they would not hit the side rails, had to re-drill holes that fastened most of the latches to the frame. If they would have taken their time installed the latches properly, then it would have been an excellent tonneau cover all over.
Love this cover. It was better than I expected. Equally as important I like working with etrailer. Good people that understand and can explain the details of their products. I have used them for a lot of stuff for my boat trailers always with good results.
This cover has made leaving items in our truck bed much easier.
I do wish it had a way to secure it when not fully open, I.e. one section open.
I bought this cover so when I tow my fifth wheel camper I can open up and still leave a section closed to cover my air compressor and inverter and when I drop the trailer I can cover my hitch and lock it. It works perfectly for my application. Great quality and sturdy.
Difficult to install
Makes noise at highway speeds
Need pliers to get latches to click into rails to hold on
Flimsy
Poor quality
Camera mounting seems off alittle compared to the original tried adjusting but still the same view
The BAKFlip G2 Hard Tonneau Cover has done an excellent job of protecting our various item in he truck bed while running around town or out camping. It is a good solution to securing items in the truck bed from casual theft.
Good product. I had to re-drill the prop rods for the cover. They were no where near where they should have been. Other than that, the installation went pretty well. Not quite as sturdy as the one I bought 15 years ago from the same company.
I have had many brands of hard covers and this one out performs the others.
The installation is critical especially with the RAM box configuration as I have.
All the parts were supplied. Take your time, read and measure twice cut once.
It’s well built and stout. Installation was a little tough. I’ve had to adjust lock tabs a few times. It sure works great keeping wheelchair covered.
This cover has been perfect for my application. Previously I had an electric motorized unit that leaked badly when it rained and had no mechanical override in the event the truck was not running. This cover is nearly waterproof and is easily opened and held open for travel if I choose to do so. It looks and works very well.
This cover works great and was very simple to instal. Didn’t take much time. The only thing I can recommend is that the instructions are kinda hard to follow at the begging.
Excellent cover! Easy to install. Looks way better on my truck than the old one and being able to fold it all the way up against the back window is very nice.
Ok the cover is great if you use it to secure items in the back but, the down fall is how the system attaches to the Ram trucks. The pressure applied by the bolts for securing the side rails causes the manufacturers bed rails to buckle in the middle which, is minimal if you live in a cold climate but, for the majority, it causes issues. I love the security but I hate what it does to my bed rails.
I ordered a Bakflip tonneau cover and fob lock for my tailgate. Instructions on the cover were perfect. It looks great. Absolutely no institutional videos on my 2011 GMC Canyon for the remote. The wiring connection portion of the install was just past tedious. Once figured out it works like a dream.
Very easy to install. I didn't use the instructions (no, I'm not one of those guys). I used the installation video on the BSK G2 tonneau cover on etrailer.com! It arrived in just a few days and was very well packaged. I can finally store things in the bed of my truck safely. Way to go etrailer and BAK Industries!!
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.