Westin HDX Install Picture for 2013 Ram 2500

Question

Question:

Question about guard for 2013 ram 2500 diesel. Does this guard have divider bar where headlight is?Ram headlight is one light not like ford or chevy with two headlights. If it has divider bar this blocks use od headlight. Thanks

asked by: Chris

0

Expert Reply:

I attached a picture that shows what the Westin HDX Grille Guard # 57-3555 looks like when installed on a 2013 Ram like your 2500 model.

It looks like the divider bar is below the headlamps.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I looked up the circuits that the IOTA IDP-240 had and since it has 50 amp circuits the best replacement we have would be the Progressive Dynamics RV Power Control Center #PD4590K18LS8 which has 12 circuits that can be rated for up to 50 amps.

view full answer...

Answer 2

To replace your Iota IDP-240 you'll want to use the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4560K18LS8. This panel is rated for 50 amp service, can provide both 120v/240v and is compatible with…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Jen, thanks for the information! Since your 2016 Ram 2500 has the Ram Boxes, you'll need to have a rotating pin box installed on your 2026 Jayco Eagle HT DDB. The rotating pin box is the only way to tow a 5th wheel trailer and not hit the Ram…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Westin HDX Install Picture for 2013 Ram 2500

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching